Constructing surface oxygen defects at CuO–Co3O4 interface to boost toluene oxidation over CuO/Co3O4 catalysts

Wei Liu,Huiqiong Yu,Shuang Yang,Zhongxian Song,Xi Chen,Xuejun Zhang
DOI: https://doi.org/10.1016/j.envres.2024.118411
IF: 8.3
2024-05-01
Environmental Research
Abstract:As a typical heterogeneous catalytic process, the catalytic combustion of toluene over Co<sub>3</sub>O<sub>4-</sub>based catalysts is strongly depends on the surface properties of catalysts, especially the concentration of surface oxygen defects. Here, a novel way was proposed to construct chemically bonded CuO-Co<sub>3</sub>O<sub>4</sub> interface by chemical deposition of CuO onto Co<sub>3</sub>O<sub>4</sub> nanoflowers. The interfacial refinement effect between CuO and Co<sub>3</sub>O<sub>4</sub> support disrupted the ordered atomic arrangement and created countless unsaturated coordination sites at CuO-Co<sub>3</sub>O<sub>4</sub> interface, inducing a significant generation of surface oxygen defects. Surface-rich oxygen vacancies enhanced the capacity of 20%CuO/Co<sub>3</sub>O<sub>4</sub>-R to adsorb and activate oxygen species. Benefiting from this, 90 % toluene conversion was reached at 228 °C over 20%CuO/Co<sub>3</sub>O<sub>4</sub>-R, which was much lower than that over 20%CuO/Co<sub>3</sub>O<sub>4</sub>-S prepared by impregnation method and CuO/Co<sub>3</sub>O<sub>4</sub>-mix obtained by mechanically mixing way. In-situ DRIFTS analysis revealed that toluene could be directly decomposed into benzaldehyde at the highly defective CuO-Co<sub>3</sub>O<sub>4</sub> interface, leading to toluene oxidation following the path of toluene → benzaldehyde → benzoate → maleic anhydride → water and carbon dioxide over 20%CuO/Co<sub>3</sub>O<sub>4</sub>-R, which was significantly different from decomposition mechanism over 20%CuO/Co<sub>3</sub>O<sub>4</sub>-S. Additionally, 20%CuO/Co<sub>3</sub>O<sub>4</sub>-R displayed terrific recyclability and outstanding stability, showing good application potential.
environmental sciences,public, environmental & occupational health
What problem does this paper attempt to address?