Eco-efficient coatings for healthy indoors: Ozone deposition velocities, primary and secondary emissions

Alessandra Ranesi,Paulina Faria,M. Rosário Veiga,Elliott T. Gall

DOI: https://doi.org/10.1016/j.buildenv.2024.111306

IF: 7.093

2024-02-16

Building and Environment

Abstract:Volatile organic compounds (VOCs) and ozone (O 3 ) are harmful pollutants present in indoor air. Indoor concentrations of VOCs are typically higher than outdoors, due to the presence of indoor sources like building materials and ozone-surface reactions. The study aims to identify and quantify the ozone reactivity and primary and secondary emissions of different indoor coatings. The coatings selected for the study were three gypsum-based plastering mortar, with and without the addition of a bio-waste from Acacia dealbata (raw bark, BA, and bark heated at 250 °C, BA250), two clay plasters (one with sand and the other with seashells as additional aggregate), applied both as basecoat and topcoat (on drywall), and one un-coated drywall. All the products tested had ozone deposition velocities that would reduce the indoor ozone concentration meaningfully if implemented in a real indoors, contributing to the improvement of indoor air quality. The gypsum-based plaster shows the lowest ozone deposition velocity, but also the lowest primary and secondary emissions. The addition of bark, either BA or BA250, increased by 50% the ozone deposition velocity of the coating but also increased primary and secondary emissions by 80% (BA) and 200% (BA250), with methanol (m/z 33.030) accounting for about 60% of the increase. The addition of crushed seashells to the formulation of the clay-based plasters lowered the secondary emission yields (102% and 120% respectively, when applied as base and topcoat).

engineering, environmental,construction & building technology, civil