Abstract:The Finite Element Method analysis of machining processes has become a ubiquitous feature to the area, however, there sometimes occur considerable deviations between experimental and simulated results due to the inherent complexity of the process. The basis for such may conceivably be related to imprecisions in the material and friction modelling, besides improper setup of mesh parameters. Elements should be small enough to allow for the proper representation of the chip formation, but taking into account that the computational time increases accordingly with mesh downsizing. Simulations of the milling process of Inconel 718 were conducted using the software Thirdwave AdvantEdge under different cutting conditions for three different meshes. Power and temperature output were compared to experimental results, most of which were measured via Hall-effect sensors and thermographic camera, respectively. The tool cutting edge radius was found to be an important factor and was estimated using Scanning Electron Microscope images. The influence of the finite element mesh size was higher for harsher cutting conditions, with effects felt on machining power only. In this case, finer mesh produced results that showed a higher agreement with experimental data, but at higher computational cost as shown by analysis of elapsed processing time. Although errors higher than 40% were observed, power and temperature trends from simulations were always in accordance with that found in experimental tests. Comparisons with experimental data from other studies showed the errors tend to grow for higher feed and cutting speed, which indicates the constitutive model of the material is more adequate for softer machining conditions. Simulation time seemed to be exponentially proportional to the inverse of minimum element size, and measured values might serve as a reference for other users.

Development of an analytical model to investigate the effect of tool geometry and cutting parameters on the milling performance of Inconel 718

Numerical Simulation Study on Milling Force for Aerospace Aluminum Alloy

Study on the Effect of Tool Inclination Angle in Machining Process Based on Three-Dimensional Thermo-Elastic-Plastic Model

Three-dimensional numerical simulation for high speed milling of aerospace aluminum alloy

Simulation of High-Speed Milling Process of Aerospace Aluminum Alloy

Influence of cutting tool geometrical parameters on tool wear in high-speed milling of Inconel 718 curved surface

Experimental Study on the Effect of Cutting Tool Geometry in Micro-Milling of Inconel 718

Numerical and experimental investigation of tool geometry effect on residual stresses in orthogonal machining of Inconel 718

Machining-Induced Work Hardening Behavior of Inconel 718 Considering Edge Geometries

Milling Mechanism and Chattering Stability of Nickel-Based Superalloy Inconel 718

Cutting Performance of a Longitudinal and Torsional Ultrasonic Vibration Tool in Milling of Inconel 718

Experimental and numerical investigation of Inconel 718 machining with worn tools

Model for the prediction of 3D surface topography and surface roughness in micro-milling Inconel 718

The effect of chip formation on the cutting force and tool wear in high-speed milling Inconel 718

RESEARCH ON CUTTING FORCE MODELLING AND INFLUENCE FACTORS FOR END MILLS WITH VARIABLE-HELIX ANGLE

Microstructure-Based Flow Stress Model to Predict Machinability of Inconel 718

Chip Formation Mechanism of Inconel 718: A Review of Models and Approaches

Numerical Modeling of the Effect of Cutting-Edge Radius on Cutting Force and Stress Concentration during Machining

Tool wear monitoring through online measured cutting force and cutting temperature during face milling Inconel 718

Multi-physics analytical modeling of the primary shear zone and milling force prediction

The effect of mesh parameters on computational cost and results in simulation of milling in Inconel 718