Abstract:Threaded fasteners were developed long time (let’s remember that Archimedes – 287-212 BC – invented the water screw). Nowadays, bolted joints are used in almost all sectors of the industry. But in spite of having been an important machine part for centuries, problems may be encountered with them. They are so common that they are taken for granted and too often, not analyzed as deeply as it should be. The wrong tightening is one of the most frequent causes of ductile rupture and by far the most frequent cause of fatigue failure. The tightening operation is never easy. It is necessary to pay particular attention to the choice of the tightening tool, the process and the control method. The tightening operation may itself cause damage on parts. The tightening load must not be too low, or excessive or not equally distributed among the bolts. These three defects can even be made on the same bolted joint! This impacts badly the performance of the assembly and leads to a shorter lifespan. If insufficient precautions are taken, the real tightening preload on all the bolts will not fit well with the requirements and would be badly distributed. Consequently, the practical conditions are quite different from the hypothesizes which are taken for the initial calculations (analytics or FEM) at the design stage. Thus, the results of the calculations of bolted joints cannot be considered as accurate and reliable. Practically, there are several means to tighten a bolt. The two ways most frequently used are torque wrench and hydraulic bolt tensioner. Torque wrench involves exerting a torque to the bolt head or the nut. Hydraulic bolt tensioner applies a traction load directly on the bolt. It is well known that bolt tensioners give better accuracy and homogeneity in the final tightening load than the torque method, but the tension load applied with the tensioner must be higher than the final remaining tightening load. So, the paper focusses on the hydraulic tensioner to show how the tightening load can be obtained from the applied tension load and to propose a way to optimize and secure the tightening process. However, for the reasons above mentioned it appears necessary to first make a general description of technical aspects of bolted joints. What really happens when tightening with torque wrench or with bolt tensioner is explained.

Optimization of aerospace engine bolt tightening based on Kriging model

Research on Process Planning Method of Aerospace Engine Bolt Tightening Based on Digital Twin

A Novel Method for Stacking Optimization of Aeroengine Multi-stage Rotors Based on 3D Deviation Prediction Model

Deformation Prediction and Compensation of a Dual-Machine Riveting System for Aircraft Assembly

Optimization of riveting parameters using Kriging and particle swarm optimization to improve deformation homogeneity in aircraft assembly

Research on Prediction Method of Bolt Tightening for Aviation Components Based on Neural Network

Online O-Ring Stress Prediction and Bolt Tightening Sequence Optimization Method for Solid Rocket Motor Assembly

Influence of the Deformation of Riveting-Side Working Head on Riveting Quality

Structural Multi-objective Optimization Design of Air-suspending Frictionless Pneumatic Cylinders

Semi-Physical Simulation Optimization Method for Bolt Tightening Process Based on Reinforcement Learning

Robust Optimization of Structural Dynamic Characteristics Based on Adaptive Kriging Model and Cnsga

A multi-bolt tightening method based on elastic interaction coefficient and gasket creep relaxation

Automotive Bolts Tightening Analysis using Contact Stress Simulation: Developing An Optimal CAE Design Approach Model

Stability analysis of nut coefficient of aero-engine rotor connection bolt

An analytically improved four-stage model for single-lap torqued bolted joints accounting for preload relaxation

Analysis and determination of bolt tightening process factors for composite structures under multiple working conditions

Tightening performance analysis of bolted connection considering non-parallel contact

Time-varying reliability analysis of compressor blisk based on particle swash optimization extreme Kriging model

Measuring Point Planning and Fitting Optimization of the Flange and Spigot Structures of Aeroengine Rotors

Optimal tightening process of bolted joints

Parametric Modeling and Updating for Bolted Joints of Aeroengine Casings