A comprehensive analysis on cost, combustion, performance and emissions for diesel engine fueled with preheated esters of waste cooking oil

Yadav, Prem Shanker

DOI: https://doi.org/10.1007/s10098-024-03017-4

IF: 4.3

2024-09-20

Clean Technologies and Environmental Policy

Abstract:The current study examines the suitability of biodiesel made from used cooking oil (WCO) utilizing heated methyl ester, ethyl ester and butyl ester as alternative fuels for combustion ignition engines. However, there has been limited investigation into the butyl ester of waste cooking oil (WCOBE) as a fuel in both unheated and preheated circumstances. The economic feasibility of biodiesel production from WCO using methanol, ethanol and butanol was analyzed. The findings indicated that heated butyl ester and ethyl ester of WCO were produced at a cost that was 44.71% and 42.5% less than diesel fuel, respectively, for 1 kWh of energy. Further, the Sauter mean diameter was measured at temperatures between 30 and 100 °C using the Malvern Spraytec laser diffraction-based system. In the temperature range found, methyl ester had a smaller Sauter mean diameter than ethyl ester and butyl ester. Furthermore, the engine characteristics showed that preheated butyl ester exhibited a peak pressure that was 0.49% higher than unheated, whereas preheated ethyl ester showed a peak pressure that was 4.7% lower. Preheated esters emitted less CO, HC and smoke during peak load than unheated esters but more NO x and CO 2 during peak load. The detail comparative results are included at the end of results and discussion.

environmental sciences,green & sustainable science & technology,engineering, environmental