Abstract:Rotating detonation experiments were conducted using CH4/CO/H2 (methane/carbon monoxide/hydrogen) mixtures with varying CO contents, the modes of rotating detonation wave (RDW) propagation in the mixtures were analyzed, and the impact of CO content on the propagation characteristics of the RDW in the gas mixture was compared. Three propagation modes of RDW were observed: sawtooth wave mode, mixed mode, and single wave mode. An increase in the CO content resulted in an upward shift in the range of working equivalence ratios for different gas mixtures. Additionally, the propagation modes of the same gas mixture change with increased fuel flow rate. When the equivalence ratio is below 1.13, it is observed that the gas mixture with the lowest CO content exhibits the highest RDW velocity and the shortest time required to establish RDW. This was attributed to the higher content of oxygen-containing functional groups, such as OH (hydroxyl), HO2 (peroxyhydroxyl), and O (oxygen atom), which were present under lean combustion conditions, along with the highest mass content of H2 in the gas mixture with the lowest CO content. Conversely, for equivalence ratios above 1.13, it is observed that the gas mixture with the highest CO content exhibits the highest propagation velocity and the shortest time required to establish RDW. This was attributed to the lowest mass content of CH4 and H2 in the gas mixture with the highest CO content at the same equivalence ratio, along with the inhibitory effect of elevated CO content on CH4 consumption under fuel-rich combustion conditions. The increase in the CO content resulted in maximum propagation velocities of the detonation wave being achieved for the three gas mixtures at equivalence ratios of 0.91, 1.09, and 1.19, with corresponding velocities of 1136.7, 1108.7, and 1113.2 m/s, and the shortest times required to establish RDW were measured at 1.5, 1.1, and 0.8 ms for the respective mixtures.

Effect of ethylene-rich gas temperature on rotating detonation auto-initiation process

Study on the Effects of Inflow Parameters on the Auto-Initiation of Hydrogen-Rich Gas Rotating Detonation

Experimental study on propagation characteristics of rotating detonation wave with kerosene fuel-rich gas

The effect of CO content on CH4/CO/H2 rotating detonation wave propagation characteristics

Effects of wave interaction on ignition and deflagration-to-detonation transition in ethylene/air mixtures behind a reflected shock

Numerical Investigation on Effects of Ignition Energy on Two-phase Detonation Wave Formation

Effects of injection parameters on propagation patterns of hydrogen-fueled rotating detonation waves

Effect of ethylene fuel/air equivalence ratio on the dynamics of deflagration-to-detonation transition and detonation propagation process

Experimental study on the effect of injection pressure ratio on the propagation characteristics of hydrogen rotating detonation waves

Experimental study on the rotating detonation engine based on a gas mixture

Experimental investigation of ethylene-fueled ramjet rotating detonation engine with an annular combustor

Experimental research on the instability propagation characteristics of liquid kerosene rotating detonation wave

Effects of the inflow total temperature on the non-premixed rotating detonation engine performances

Investigation of rotating detonation fueled by the pre-combustion cracked kerosene

Experimental Study on the Propagation Characteristics of Rotating Detonation Wave with Liquid Hydrocarbon/High-Enthalpy Air Mixture

Numerical study on ethylene-air continuous rotating detonation in annular combustors with different widths

Experimental research on initiation characteristics of a rotating detonation engine

Effects of Temperature Perturbation on Direct Detonation Initiation

Effects of Thermal Wall Conditions on Rotating Detonation

Experimental study of H2/air rotating detonation wave propagation characteristics at low injection pressure

Effects of Isothermal Wall Boundary Conditions on Rotating Detonation Engine