0D, 1D, and 2D Supramolecular Nanoassemblies of a Porphyrin: Controllable Assembly, and Dimensionality‐Dependent Catalytic Performances

Peng Li,Guojing Xu,Nannan Wang,Bo Guan,Shuiqing Zhu,Penglei Chen,Minghua Liu

DOI: https://doi.org/10.1002/adfm.202100367

IF: 19

2021-02-25

Advanced Functional Materials

Abstract:<p>While tremendous advances have been made in dimensionality‐dependent performances of inorganic‐based low‐dimensional nanostructures, paradigms concerning π‐conjugated molecule‐based supramolecular nanoassemblies are relatively fewer despite their various intrinsic advantages. It is herein reported that 0D, 1D, and 2D supramolecular nanostructures of a porphyrin, 5,10,15,20‐tetrakis(4‐aminophenyl)‐21H,23H‐porphine, with a spherical, fibrous and sheetlike architecture, respectively, could be fabricated via a reprecipitation protocol. As a typical example to demonstrate their dimensionality‐dependent optoelectronic performances, it is shown that the nanomaterials could serve as photocatalysts for water remediation, where the catalytic reactivity exhibits a trend of nanofibers<b>&gt;</b>nanospheres<b>&gt;</b>nanosheets. The superior catalytic reactivity of the nanofibers stems from the formation of relatively well‐defined J‐aggregates with orderly and tightly organized chromophores, conferring them with strong photoinduced electron–hole transport and separation capability. The higher catalytic reactivity of the nanospheres than nanosheets results from their larger specific surface area, which facilitates efficient accessibility of photogenerated charge carriers, although the porphyrins therein form unspecific J‐aggregates with disorderly and loosely stacked chromophores. The investigation likely initiates a simple method for π‐conjugated molecule‐based 0D, 1D and 2D nanoassemblies by using the same tectons, based on which the highlighted underlying scientific insights might provide useful clues for rational design of organic‐based low‐dimensional advanced soft materials.</p>

materials science, multidisciplinary,chemistry, physical,physics, applied, condensed matter,nanoscience & nanotechnology

What problem does this paper attempt to address?

The problem that this paper attempts to solve is to explore the performance differences of low - dimensional nanostructured materials based on π - conjugated molecules in different dimensions and the scientific mechanisms behind them. Specifically, the authors successfully prepared 0D (nanospheres), 1D (nanofibers) and 2D (nanosheets) supramolecular nano - assemblies by using the same tetra - aminophenyl porphyrin (TAPP) molecules as building units through a simple reprecipitation method. The performance of these nanostructures in photocatalytic water treatment shows an obvious dimensional dependence, among which nanofibers exhibit the best catalytic activity, followed by nanospheres, and finally nanosheets. This difference is mainly attributed to the different arrangements of porphyrin molecules in nanostructures of different dimensions, which lead to different photo - induced electron - hole transport and separation capabilities, as well as the influence of specific surface area. Through this study, the authors not only provide a simple and controllable method for preparing multi - dimensional nanomaterials based on π - conjugated molecules, but also provide important scientific insights for further understanding and designing high - performance organic optoelectronic soft materials.