Abstract:Annular thermoelectric power generator has been increasingly considered in application of ambient energy harvesting owing to the advantages of simple structure and no pollution. To improve thermal stability and energy harvesting performance of this system, the latent heat of phase change materials to improve thermal management and the high thermal conductivity of the heat sink to enhance heat transfer with the ambient are harness to annular thermoelectric power generator. Motivated by this, a phase change material based annular thermoelectric energy harvester (PCM-ATEH) with fins is developed for ambient energy harvesting and its three-dimensional transient model is also built up through jointly with thermo-electric and phase change processes . This paper considers the influence of key parameters such as temperature fluctuation amplitude, temperature fluctuation period, height ratio of PCM and thermoelectric generator (TEG) and melting temperature on liquid fraction, temperature difference, voltage and power density. Moreover, the comparison of PCM-ATEH and PCM based thermoelectric energy harvester (PCM-TEH) with/without fins is further conducted in this study to explore thermal management and energy harvesting performance. The energy harvesting characteristics of PCM-ATEH with fins is developed concerning the combination of power generation of TEG and melting process of PCM. Based on the results, it is found that the temperature difference and power density of PCM-ATEH with fins vary periodically with the sinusoidal temperature boundary, and results show that increasing temperature fluctuation period is not always feasible. Additionally, the comparative results indicate that the peak power density and energy efficiency of PCM-ATEH with fins are increased by 0.126 W/m 2 and 0.02 % compared with PCM-TEH with fins, and increased by 0.195 W/m 2 and 0.041 % compared with PCM-ATEH without fins. The results of energy harvesting characteristics show that a maximum of 0.77$ per watt can be reached to power generation cost of PCM-ATEH with fins. This paper can provide theoretical guidance for thermal management and energy conversion of energy harvesting system.

A phase change material based annular thermoelectric energy harvester from ambient temperature fluctuations: Transient modeling and critical characteristics

A comprehensive investigation of PCM based annular thermoelectric generator for energy recovery: Energy conversion characteristics and performance evaluation

Experimental Investigation on Thermal Performance of Phase Change Materials–metal Foam Composites in Ocean Thermal Engine

Efficiency and Power Density Analysis on Phase Change Material-Based Ocean Thermoelectric Generator for Underwater Vehicle

Experimental Research of an Ocean Thermal Engine with Phase-Change Material

Numerical and Experimental Study of the Ocean Thermal Energy Capture Process Utilizing Metal Foam–phase-Change Material (PCM) Composites

Investigation of a Double-Pcm-based Thermoelectric Energy-Harvesting Device Using Temperature Fluctuations in an Ambient Environment

Investigation on the Melting Performance of a Phase Change Material Based on a Shell-and-Tube Thermal Energy Storage Unit with a Rectangular Fin Configuration

Analysis of reducing thermal resistance between the PCM and ambient air for improving the power generation characteristics of PCM-based thermoelectric power generators

Optimized output electricity of thermoelectric generators by matching phase change material and thermoelectric material for intermittent heat sources

Active cooling performance of a PCM-based thermoelectric device: Dynamic characteristics and parametric investigations

Thermoelectric Energy Harvesting Using Phase Change Materials (PCMs) in High Temperature Environments in Aircraft

Heat transfer mechanism and structure design of phase change materials to improve thermoelectric device performance

Multiple Energy Harvesting Based on Reversed Temperature Difference Between Graphene Aerogel Filled Phase Change Materials

Experimental investigation on the influence of phase change material on the output performance of thermoelectric generator

Operational and structural parametric analysis of a photovoltaic/thermal system integrated with phase change material

Integration of thermal insulation and thermoelectric conversion embedded with phase change materials

Optimization and thermal performance of U-type evacuated tube solar collector filled with phase change material

Numerical analysis of a solar driven thermoelectric generator brick with phase change materials: Performance evaluation and parametric investigations

Numerical investigation of heat transfer mechanism in an embedded PCM-TEG for better overall performance under the fluctuating heat source

Optimization Design and Performance Study of Wearable Thermoelectric Device Using Phase Change Material as Heat Sink