Abstract:Solvent extraction is an efficient method that separates surfactants and pollutants in pumped groundwater during surfactant-enhanced aquifer remediation (SEAR). This paper addresses the factors that influence the extraction efficiency of solvent extraction method. A series of batch experiments were conducted to verify the effectiveness of solvent extraction by describing the interactions among contaminants, surfactants, and solvents, using factors such as extraction time, solvent/water volumetric ratio, surfactant type and concentration, contaminants type and concentration, solution salinity and solvent equivalent alkyl carbon numbers (EACNs). The surfactants, contaminants, and solvents used were sodium dodecyl sulfate (SDS) and Tween 80, benzene and nitrobenzene, n-hexane, n-decane and n-hexadecane, respectively. The results indicated that (I) the increase in extraction time or solvent/water volumetric ratio caused higher benzene removal efficiency, but the increment of removal was not significant after 2 h or 0.1; (2) surfactant type and concentration significantly affected extraction efficiency. The increase in SDS concentrations could generally increase benzene removal and then decline, whereas benzene removal seldom changed under the studied Tween 80 concentration range. Moreover, Tween 80 losses were much lower than that of SDS. When mixing the two surfactants, benzene was increasingly separated from the aqueous surfactant solutions by increasing the proportion of Tween 80, and surfactant losses almost depended on monomers instead of micelles within the aqueous surfactant solutions; (3) the efficiency of separating benzene from aqueous surfactant solutions was higher than that of nitrobenzene. Furthermore, n-hexane losses in the benzene aqueous solution were higher than that in the nitrobenzene aqueous solution; (4) higher inorganic salt concentration in the aqueous Tween 80 solutions could increase benzene removal and decrease Tween 80 losses, thereby improving extraction efficiency; (5) n-hexane was more suitable to separate benzene from aqueous Tween 80 solutions because its EACN was closest to the EACN of benzene. (C) 2014 Elsevier B.V. All rights reserved.

Solvent extraction of uranium from leach liquor using dibutyl carbitol: optimization of parameters by response surface methodology

Laboratory Evaluation of the Use of Solvent Extraction for Separation of Hydrophobic Organic Contaminants from Surfactant Solutions During Surfactant-Enhanced Aquifer Remediation

Highly efficient diluent-free solvent extraction of uranium using mixtures of protonated trioctylamine and quaternary ammonium salts. Comparative Life Cycle Assessment with the conventional extractant

Uranium extraction from sulphuric acid leach liquor by Cyanex®272 as intermediate in nuclear fuel cell

SYNTHESIS AND CHARACTERIZATION OF DIBUTYLACYLAMINE AS A NEW EXTRACTANT

URANIUM-THORIUM SEPARATION BY DI-SEC-BUTYLPHENYLPHOSPHONATE EXTRACTION

Organic solvent extraction of uranium from alkaline nuclear waste

High performance task-specific ionic liquid in uranium extraction endowed with negatively charged effect

Recovery of uranium from phosphate ore of Iran mine: Part II- solvent extraction of uranium from wet-process phosphoric acid

Uranium (VI) sorption from aqueous solution using commercial anion exchange resins; kinetics, isotherm, and thermodynamic investigations

Extraction of Uranium From Nitric Acid Medium by TBP in Room-Temperature Ionic Liquids

Optimization of process parameters using response surface methodology for Pd(II) extraction with quaternary ammonium salt from chloride medium: kinetic and thermodynamics study

Separation and recovery of uranium and beryllium from acidic sulphate solutions by solvent extraction using mixture of organophosphonic extractants

Advanced Uranium Removal with Pure, Nonfluorinated Ionic Liquids: Fine-Tuning Hydrophilic and Hydrophobic Properties for Enhanced Selectivity

Study on uranium leaching from uranium purification residue with ammonium hydrogen fluoride

Fabrication of Novel Carboxyl and Amidoxime Groups Modified Luffa Fiber for Highly Efficient Removal of Uranium(vi) from Uranium Mine Water

Recovery of uranium from phosphate ore in the Sheikh Habil-Iran mine: part I— multivariable optimization of leaching process using the response surface method

Molecular and Supramolecular Study of Uranium/Plutonium Liquid-Liquid Extraction with N, N-Dialkylamides

Numerical Simulation of Uranium Extraction from Nitric Acid Medium Using Hollow-Fiber Contactor

Application of acidic deep eutectic solvents in green extraction of 5-hydroxymethylfurfural

Solvent Extraction of Strontium from Nitric Acid Medium by Di-Tert-butyl Cyclohexano-18-crown-6 in N-Octanol: Extraction Behavior and Flowsheet Demonstration