Abstract:When implementing the traditional assembly method, the rotor is affected by machining errors. The morphology of the rotor is complex, and the machining error of the rotors at all levels are transmitted step by step through the stop mating surface, which affects the performance and service life of the aero-engine. The evaluation of machining error of single-stage rotor is the basis of assembly quality of multi-stage rotor. In order to improve the current situation of complicated and time-consuming rotor machining error evaluation, this paper proposes to establish a deep belief neural network (DBNN) to replace the traditional procedure of depolarization. The network takes the relative evaluation error of the rotor profile data without depolarization as the input and takes the machining error of the rotors obtained after depolarization as the output. First, the evaluation mechanism of the rotor's machining error is analyzed, and the corresponding machining error influence source is selected as the input source of the deep belief neural network. Second, as DBNN is trained, and the appropriate weight initialization method and the optimization algorithm of the prediction network are selected to ensure the optimization of the whole network for feature mapping extraction of the training set. Finally, the assembly of multi-stage rotors is simulated and analyzed. It is shown in the experiments that after the iteration, the prediction network, with good training effects, has converged, and its prediction results tend to be consistent with the real values. The mean prediction error of the concentricity is 0.09 µm while the mean difference of angle of concentricity error value is 0.77°, and the mean difference of perpendicularity error value is 0.21 µm while the mean difference of angle of perpendicularity error value is 1.4°, the corresponding R2 determination coefficients were 0.99, 0.98, 0.91, and 0.94, respectively. It meets the requirements of field assembly and fully embodies the effectiveness of the procedure of depolarization based on deep confidence neural network.

Unbalance prediction method of aero-engine saddle rotor based on deep belief networks and GA-BP intelligent learning

Prediction of the Parallelism Error and Unbalance of Aero-Engine Rotors Based on Intelligent Algorithm

A Novel Method for Stacking Optimization of Aeroengine Multi-stage Rotors Based on 3D Deviation Prediction Model

An Unbalance Optimization Method for a Multi-Stage Rotor Based on an Assembly Error Propagation Model

Measurement method of aero-engine rotor concentricity and perpendicularity based on deep belief neural network

Unbalance Prediction of Low Pressure Rotor Based on Mechanism and Data Fusion

Research on intelligent assembly method of aero-engine multi-stage rotors based on SVM and variable-step AFSA-BP neural network.

Coaxiality and perpendicularity prediction of saddle surface rotor based on deep belief networks

Research on Balancing Method of Single-Stage Rotor Blade Mass Moment Based on Pointer Network

Prediction Method of Aeroengine Rotor Assembly Errors Based on a Novel Multi-Axis Measuring and Connecting Mechanism

A method to minimize stage-by-stage initial unbalance in the aero engine assembly of multistage rotors

Unbalance Compensation by Recursive Seeking Unbalance Mass Position in Active Magnetic Bearing-Rotor System

Prediction Method of Concentricity and Perpendicularity of Aero Engine Multistage Rotors Based on PSO-BP Neural Network

A Prediction Model of Multi-stage Rotors Coaxiality Based on Neural Network

Rotor unbalance fault diagnosis using DBN based on multi-source heterogeneous information fusion

A Two-Stage Deep-Learning-based Balancing Method for Rotating Machinery

A novel rotor dynamic balancing method based on blade tip clearance measurement without the once per revolution sensor

Unbalance Compensation for Active Magnetic Bearing Rotor System Using a Variable Step Size Real-Time Iterative Seeking Algorithm.

Development and Experimental Validation of a Model-Based Balancing Prediction Method for Bowed Rotor

Unbalance Error Compensation Method of Aircraft APU Turbine Rotor Based on Blade Sorting

A Genetic Algorithm Based Balancing Framework for Flexible Rotors