Synthesis of highly effective CuO–FeSe2 composites for the photodegradation of RhB under visible light

DOI: https://doi.org/10.1007/s11164-024-05286-6
IF: 3.134
2024-05-15
Research on Chemical Intermediates
Abstract:The release of industrial effluents into fresh water is a major contributor of water contamination. Therefore, it is highly desirable to develop a viable solution to this alarming issue to improve the quality of clean water. To enhance the photocatalytic efficiency and hence utilization ratio of CuO, a series of CuO–FeSe 2 composites with different varying contents of FeSe 2 were prepared through facile synthetic methods. X-ray diffraction (XRD) and energy-dispersive X-rays (EDX) analysis verified that the samples were successfully prepared without any contaminating phases. The average crystallite sizes of CuO and FeSe 2 were computed to be 29 and 21 nm respectively. For the CuO–FeSe 2 composites, the crystallite sizes varied between 25 and 27 nm. The morphology of CuO was comprised of needle-shaped structures, whereas that of FeSe 2 was observed to be flower-shaped structures comprising of irregular crystals. A red shift in the bandgap of CuO–FeSe 2 composites was observed with the increase in FeSe 2 concentration. The prepared photocatalysts were utilized to evaluate their efficiency under visible light against Rhodamine B (RhB). Among all the prepared composites, CuO–75% FeSe 2 revealed a remarkable performance and degraded 96% RhB in 180 min. Rate constants for the degradation of the dye were determined by applying the Langmuir–Hinshelwood model.
chemistry, multidisciplinary
What problem does this paper attempt to address?