Abstract:In the present study, water-oil flow patterns and slug hydrodynamics were experimentally studied in square glass microchannels with various hydraulic diameters (Dh = 600 μm, 400 μm, 200 μm). The aqueous phase is the continuous phase while the organic phase is the dispersed phase. The ranges of flow rates of the continuous phase and the dispersed phase are 0–200 ml/h and 0–12 ml/h, 0–120 ml/h and 0–6 ml/h, and 0–60 ml/h and 0–2 ml/h in the microchannels with Dh = 600 μm, 400 μm and 200 μm, respectively. The results show that the hydraulic diameter has significant effects on flow patterns and three main flow patterns are observed, i.e., annular flow, slug flow and droplet flow. Generally, annular flow appeared at high flow rates of the dispersed phase and low flow rates of the continuous phase, while droplet flow appeared at low flow rates of the dispersed phase and high flow rates of the continuous phase. However, slug flow existed at comparable flow rates of the continuous and dispersed phases. A dimensionless analysis is carried out and a new dimensionless group including Weber number and Reynolds number is derived. The new defined dimensionless group performs well to develop a general flow pattern map. In addition, slug flow hydrodynamics are investigated as well in the present study, considering the slug length and slug velocity. Based on the present experimental results, a new scaling law is proposed to predict the slug length and it shows a good agreement with the experimental results. It has been widely reported that slug velocities depend linearly on the total flow rates of the two phases, which is consistent with the present study. The linear law provides a good prediction of the experimental slug velocities but different slopes are suggested in microchannels with different hydraulic diameters.

Flow behavior and characteristic parameters of droplets in counter-current mini-channel extractor

Liquid-liquid Two-Phase Flow and Mass Transfer in T-shaped Micro-Channel Network

Inner circulation flow characteristics of coalescence droplets in microchannel

WATER-OIL FLOW IN SQUARE MICROCHANNELS WITH A CROSSED JUNCTION

Saturated Flow Boiling Heat Transfer of R1233zd(E) in Parallel Mini-Channels: Experimental Study and Flow-Pattern-based Prediction

Microdroplet-based continuous countercurrent extraction with high phase ratio

Continuous Counter-Current Multistage Microextraction in a Novel Tube-In-Tube Microextractor

Mixing Efficiency Analysis On Droplet Formation Process In Microchannels By Numerical Methods

Study on Liquid–Liquid Droplet Flow Separation in a T-Shaped Microseparator

Measurement of Internal Flow Field During Droplet Formation Process Accompanied with Mass Transfer

Experimental Investigation on Submerged Gas-Liquid Mixture Injection into Water Through A Micro-Channel

Experimental Investigation of Oil Film Flow and Droplets Behavior in the Annular Channel of a Cyclone Separator

Liquid–Liquid Two-Phase Flow and Size Prediction of Slug Droplets in Microchannels

Enhancement of Mass Transfer Performance of Liquid–liquid System by Droplet Flow in Microchannels

Numerical simulation of droplet formation in a Co-flow microchannel capillary device

Experimental Study of Liquid–liquid Dispersion Patterns in T-inlet Microchannels with Different Junction Angles

A Microsystem Based on Micro-Capillary Jetting for Intensifying Countercurrent Extraction with High Phase Ratio

Application of CFD Numerical Simulation Image Imaging Technology in the Study of Droplet Microfluidic Multiphase Flow Characteristics

Experimental Studies of Droplet Formation Process and Length for Liquid–Liquid Two-Phase Flows in a Microchannel

Hydrodynamics and Mass Transfer of Liquid-Liquid Two-Phase Flow in Circular Milli-Channels: Sizing-up Effect

Flow and mass transfer characteristics in a falling-film extractor using hollow fiber as packing