Abstract:A new Ni–Co base precipitation-hardened superalloy designed using the low stacking fault energy (SFE) was used primarily in the hot components of aeroengines designed with low SFE exposed to high temperatures. Different microstructures of the new alloys were obtained by controlling the solution treatment temperature. The corresponding mechanical properties were tested at 25 °C and 750 °C. The primary γ' precipitates dissolved with increasing solution temperature, causing grain growth and an increasing microtwin fraction. Fine-grained, transient, and coarse-grained zones were formed in sequence because of the interaction between the γ′ phase and microtwins. The tensile strength decreased as the grain grew when tested at room temperature, and the strengthening mechanism was dislocation strengthening. However, when the tensile experiment temperature was increased to 750 °C, the tensile properties increased from the fine-grained to the transient zone and then decreased to the coarse-grained zone. Moreover, the fracture mechanism changed from ductile fracture to a mixed ductile and brittle fracture. The size of the secondary γ′ precipitates increased by 32 nm because the dissolved primary γ′ precipitated when the solution temperature was increased from 1090 °C to 1120 °C, which improved the tensile properties. The electron channeling contrast imaging and transmission electron microscopy results confirmed that microtwins were formed during the tensile process at 750 °C. The microtwins hindered the dislocation movement. Therefore, the transient zone of the low-SFE alloy demonstrated the best mechanical properties, which guided the optimization direction of the alloy design and service.

Effect of internal nitridation on microstructure and mechanical properties of cobalt-based superalloy under high-temperature nitrogen atmosphere

Effects of Nitrogen Content on Microstructures and Tensile Properties of a New Ni–Fe Based Wrought Superalloy

Stabilization of mechanical strength in a nanocrystalline CoCrNi concentrated alloy by nitrogen alloying

Effect of carbon addition on microstructure and mechanical properties of a typical hard-to-deform Ni-base superalloy

Microstructure Evolution and Mechanical Performance of Nickel Based Superalloy C1023 at Elevated Temperatures

Internal Nitridation of Ni-Based Superalloy IN617 During Aging at 950 °C

Effect of N Content on Mechanical Properties and Microstructure of Alloy 690

Effects of Al content on microstructures and high-temperature tensile properties of two newly designed CoNi-base superalloys

Study on the high temperature tensile properties and strengthening mechanism of nitrogen containing nickel‐based deposited metals

Effect of N Content on Microsegregation, Microstructure and Mechanical Property of Cast Ni-Base Superalloy K417g

Microstructure and mechanical properties of a new Ni–Co based superalloy at intermediate temperatures

The Effect of the Cooling Rates on the Microstructure and High-Temperature Mechanical Properties of a Nickel-Based Single Crystal Superalloy

Effect of γ' phase and microtwins on the microstructural evolution and mechanical properties of a novel Ni–Co base superalloy

Effects of Long Term Thermal Exposure on Microstructure and Mechanical Property Evolution of a New Wrought Ni–Fe Based Superalloy

Effects of Nitrogen Addition on Microstructure and Grain Boundary Microchemistry of Inconel Alloy 690

Accelerated High-Temperature Creep Failure Induced by Internal Nitridation of In617 Superalloy

Microstructure evolution and its impact on mechanical properties of a cobalt-based superalloy subjected to long-term heat-treatments

Effect of nitrogen on microstructure and mechanical properties of CrMnFeVTi6 high entropy alloy

Carbon addition and temperature dependent tensile deformation resistance and capacity of a low-cost 3rd-generation Ni-based single crystal superalloy

Effect of Microstructure on High Temperature Mechanical Properties in Forming Ni-20cr-10mo-10co Superalloy

Effect of Nitridation on the Oxidation Behavior of TiAl-based Intermetallic Alloys