Abstract:To solve the problem of the control accuracy in electrohydraulic loading systems caused by load increment, this paper proposes a multi-cylinder electrohydraulic digital loading (MEDL) technology for accurate reproduction of large load. A traditionally used single cylinder loading (SCL) is replaced by a new hydraulic cylinders group that includes N hydraulic cylinders at each point, in which one is controlled by the electrohydraulic servo valve and the others (N-1) are controlled by the on-off valve. The areas of the on-off valve controlled (OVC) cylinders form an increasing geometric sequence with a common ratio of 2. In addition, the force of the servo valve controlled (SVC) cylinder can be regulated continuously, and the OVC cylinders have only two states of no force or maximum force. There should be no force tracking error caused by nonlinear factors for the OVC cylinders. Thus, a continuous accurate large loading can be achieved by changing the working area of the cylinders group. Moreover, an improved full closed-loop (FCL) control strategy is proposed to solve the load reverse sudden change caused by the asynchronous opening and closing of the servo valve and on-off valve. With a case of N = 4 for MEDL, AMESim simulation results illustrated that the tracking error of the 4-cylinder group was about 1/6 of the single cylinder under a case of 40 kN. Furthermore, extensive experiments conducted on a real full loading bench under the FCL control method indicated that compared with SCL, the tracking error of the 4-cylinder group with a multi-step signal and various-frequency sinusoidal signals were reduced by 73% and 46%, respectively. Both simulation and experimental results proved that the proposed MEDL technology improved the loading accuracy and optimized the dynamic performance of the system.

Research on AGC Nonlinear Compensation Control for Electro-Hydraulic Servo Pump Control of a Lithium Battery Pole Strip Mill

Pump-Controlled AGC Micro-Displacement Position Control of Lithium Battery Pole Strip Mill Based on Friction Model

Precision Servo Control of GMA Based on Compounding Feedforward Compensation

Nonlinear Modeling on Electro Hydraulic Servo System and SSA Control

A Combined Nonlinear Pid Control and Cross-Coupled Pre-Compensation Control in Hydraulic Excavator

Passivity-Based PI Control for AGVs Wireless Power Transfer System

Research on Pump-Controlled AGC Micro-Displacement Position Control of Lithium Battery Pole Strip Mill Based on Friction Compensation Control Strategy of Imoroved LuGre Pattern

Nonlinear Supply Pressure Control for a Variable Displacement Axial Piston Pump

Research on 2-stage Electro-hydraulic Position Servocontrol Based on Heavy Load and Long Working Stroke Position Control System

A hybrid control strategy for the GPCM electro-hydraulic position servo control system

Adaptive Robust Motion Control of a Fast Forging Hydraulic Press Considering the Nonlinear Uncertain Accumulator Model.

Research on Position Control of an Electro–Hydraulic Servo Closed Pump Control System

Accurate Motion Control of Linear Motors with Adaptive Robust Compensation of Nonlinear Electromagnetic Field Effect

Dynamic Analysis and Improvement of the Electrohydraulic System under Power Limitation Control.

RESEARCH ON COMPENSATION FOR VARIABLE DEAD-ZONE CHARACTERISTIC OF ELECTRO-HYDRAULIC PROPORTIONAL DIRECTION VALVE IN POSITION CONTROL

Multi-cylinder electrohydraulic digital loading technology for reproduction of large load

Pump-Based Compensation for Dynamic Improvement of the Electrohydraulic Flow Matching System.

Adaptive Positioning Control of Servomotor Based on Model Identification

Motion Control of Electro-Hydrostatic Actuators with Modeling and Compensation of Nonlinear Bulk Modulus

Inverse Compensate and Control for GMA Hysteresis in Non-Circular Cutting

Research on Dynamic Performance of Independent Metering Valves Controlling Concrete-Placing Booms Based on Fuzzy-LADRC Controller