Highly Stable and Recyclable Sequestration of CO 2 Using Supported Melamine on Layered-Chain Clay Mineral

Jiangtao Peng,Haowei Sun,Jian Wang,Fagui Qiu,Peiping Zhang,Weikun Ning,Dan Zhang,Wenqing Li,Cundi Wei,Shiding Miao
DOI: https://doi.org/10.1021/acsami.0c22333
2021-02-24
Abstract:A type of highly stable and recyclable clay-based composite was developed for sequestration of CO<sub>2</sub>, which was synthesized by loading melamine (MEL) onto attapulgite (ATT) via a wet impregnation method. The synthesized materials were characterized by N<sub>2</sub> adsorption–desorption, Fourier transform infrared spectroscopy (FTIR), thermogravimetric analysis (TG), and transmission electron microscopy (TEM). By means of thermal and acidic treatments more active sites of ATT were exposed, and large surface areas were obtained. The MEL molecules were well combined with those exposed sites, which enhanced stability and cyclability for CO<sub>2</sub> sequestration. On the basis of CO<sub>2</sub> adsorption–desorption measurements, the composite of ATT-MEL was found to have a higher CO<sub>2</sub> adsorption capacity (4.91 cm<sup>3</sup>/g) which was much higher than that of CO<sub>2</sub> absorption on bare MEL (1.30 cm<sup>3</sup>/g) at 30 °C. After ten cycles of reusing, the composite exhibited even higher capacity for CO<sub>2</sub> adsorption by an increased percentage of 5.91% (30 °C) and 5.77% (70 °C) compared to the capacity in the first cycle. The reason lies in the strong interaction between melamine and attapulgite matrix which was further confirmed by DFT calculations. The MEL was validated to have advantages over aliphatic amines (TEPA) in modifying ATT to get high stability of CO<sub>2</sub>-adsorbents.This article has not yet been cited by other publications.
materials science, multidisciplinary,nanoscience & nanotechnology
What problem does this paper attempt to address?