Abstract:This study examines the effect of ink composition on the ionomer distribution in the catalyst layer of membrane electrode assemblies (MEA) prepared by decal transfer. We combine both structural and electrochemical characterization techniques to investigate the inﬂuence of the ionomer distribution on MEA performance determined by 50 cm 2 active area single-cell proton exchange membrane (PEM) fuel cell measurements. Cathodic catalyst layers were prepared from inks with different alcohols (1-propanol or 2-propanol) and varying water content (16–65 wt% H 2 O). The H 2 /air performance of cathode catalyst layers prepared from the different inks with 700 EW ionomer differed drastically, particularly under wet operating conditions, whereby the best performance was obtained for an ink based on 16 wt% H 2 O in 1-propanol. This was successfully correlated with the observation of ionomer patches at the cathode electrode surface (i.e., the surface facing thediffusionmedium) determinedbyscanning electron microscopy (SEM),with N 2 adsorption analysis of the electrodes using a QSDFT model, and with dynamic light scattering data of ionomer/solvent mixtures. No correlation could be obtained between H 2 /air performance and the proton conductivity of the cathodes obtained by electrochemical impedance spectroscopy, and a model to rationalize this behavior will be proposed.

Ink Solvent Dependence of the Ionomer Distribution in the Catalyst Layer of a PEMFC