Abstract:Over the past two decades the use of near-/super-critical carbon dioxide has received much attention as a green alternative to organic solvents for chemical reactions, separations, and extractions because of its pressure-tunable physicochemical properties and economic advantages. However the advantages are diminished because of a relative narrow range of CO2-soluble materials. The goal of this work is to identify, design and synthesize oxygenated hydrocarbon-based CO2-soluble polymers that are able to serve as construction blocks for copolymers, dispersants, surfactants, thickeners, and chelating agents. Without concerning on the cost and the environmental persistence like fluorinated materials, the inexpensive, environmentally benign materials would significantly enhance the viability of near-/super-critical carbon dioxide-based technology. Based on both experimental heuristics and ab initio simulation results of molecular modeling (performed by Dr. Johnson's group), we proposed specific new polymer structures: poly(3-acetoxy oxetane) (PAO), poly(vinyl methoxymethyl ether) (PVMME), poly(vinyl 1-methoxyethyl ether) (PVMEE), and cellulose triacetate (CTA) oligomers. Phase behavior studies were also performed with novel CO2-philic compounds containing vinyl acetate, propylene glycol, or multiple tert-butyl groups. PAO, PVMME and PVMME were soluble in CO2, but not as soluble as poly(vinyl acetate). Oligomers of cellulose triacetate with as many as four repeat units solubilized into dense CO2 less than 14 MPa in the concentration range of 1-5 wt%. Phase behaviors of more than thirty compounds in dense CO2 were studied in this project. A new type of phase behavior for solid (at ambient temperature) CO2-philes that melt and dissolve in CO2 was detailed using a model binary mixture of β-D-maltose octaacetate and CO2. Copolymers of tetrafluoroethylene (TFE) and vinyl acetate (VAc) exhibited lower miscibility pressures than either of the homopolymers, probably due to quadradentate binding configurations with CO2. Phase behavior investigation of poly(propylene glycol) (PPG) monobutyl ether in CO2 demonstrated ether-CO2 interactions should receive as much attention as carbonyl-CO2 interactions when designing CO2-philic functional groups. 1,3,5-tri-tert-butylbenzene and tri-tert-butyl-phenol were both extraordinarily soluble in CO2, and are excellent candidates for CO2-soluble sand binders. In summary, although a new CO2 thickener was not identified, new non-fluorous CO2-soluble materials were identified that were, in general, acetate-rich with flexible chains, weak self-interactions, and multidentate interaction between CO2 and solute functional groups.

Rapid Dissolution of High Concentration Poly(3-hydroxybutyrate) using Neoteric Biosolvent: Experiment and molecular dynamics simulation

A novel strategy for extraction of intracellular poly(3-hydroxybutyrate) from engineered Pseudomonas putida using deep eutectic solvents: Comparison with traditional biobased organic solvents

Biomass Extraction Using Non-Chlorinated Solvents for Biocompatibility Improvement of Polyhydroxyalkanoates

Extraction Condition Optimizing Of Poly (3-Hydroxybutyric Acid) From Microorganism Using Response Surface Methodology

A Coordination Strategy to Achieve Instant Dissolution of a Biomedical Polymer in Water Via Manual Shaking.

Dissolution Dynamics of a Binary Switchable Hydrophilicty Solvent -- Polymer Drop into an Acidic Aqueous Phase

Dissolution Dynamics of a Binary Switchable Hydrophilicity Solvent-Polymer Drop into an Acidic Aqueous Phase

Physicochemical cell disruption of Bacillus sp. for recovery of polyhydroxyalkanoates: future bioplastic for sustainability

Scalable and Sustainable Processing of Intracellular Polyhydroxyalkanoates with Biobased Solvents

Room temperature dissolving cellulose with a metal salt hydrate-based deep eutectic solvent

Influence of Solvent Type on Acceleration of Phase Transition from Phase II to Phase I of Polybutene-1 via Solvent Vapor Treatment

Engineering solvation in initiated chemical vapour deposition for control over polymerization kinetics and material properties

IDENTIFICATION, DESIGN AND SYNTHESIS OF OXYGENATED HYDROCARBON-BASED CO2-SOLUBLE POLYMERS FOR CHEMICAL AND PETROLEUM ENGINEERING APPLICATIONS

The Effect of Acetic Acid as a Solvent on the Structure and Properties of Poly(3-hydroxybutyrate)—Based Dried Gels

Green Williamson enhancement of the hydrophobic properties of cellulose fibers: thermodynamic study and application to elaborate rosemary essential oil (REO) biodegradable plastic coacervates

Experimental and theoretical characterization of the release kinetic of carvacrol as inclusion complexes with β-cyclodextrin in poly(lactic acid) and Mater-Bi® processed by supercritical impregnation

Solvent hydrolysis rate determines critical quality attributes of PLGA microspheres prepared using non-volatile green solvent

Green synthesis of a superhydrophobic porous organic polymer for the removal of volatile organic compounds at high humidity

A novel temperature-responsive biphasic deep eutectic solvent-based solvent system: Integrated efficient extraction, enrichment and recovery of phytochemicals

Insight of organic molecule dissolution and diffusion in cross-linked polydimethylsiloxane using molecular simulation

Rheology and dissolution capacity of cellulose in novel [mTBNH][OAc] ionic liquid mixed with green co-solvents