Abstract:Hybrid organic–inorganic perovskite solar cells (PSCs) are receiving huge attention owing to their marvelous advantages, such as low cost, high efficiency, and superior optoelectronics characteristics. Despite their promising potential, charge-carrier dynamics at the interfaces are still ambiguous, causing carrier recombination and hindering carrier transport, thus lowering the open-circuit voltages (Voc) of PSCs. To unveil this ambiguous phenomenon, we intensively performed various optoelectronic measurements to investigate the impact of interfacial charge-carrier dynamics of PSCs under various light intensities. This is because the charge density can exhibit different mobility and charge transport properties depending on the characteristics of the charge transport layers. We explored the influence of the hole transport layer (HTL) by investigating charge transport properties using photoluminescence (PL) and time-resolved (TRPL) to unveil interfacial recombination phenomena and optoelectronic characteristics. We specifically investigated the impact of various thicknesses of HTLs, such as 2,2′,7,7′-tetrakis[N,N-di(4-methoxyphenyl)amino]-9,9′-spirobifluorene (spiro-OMeTAD), and poly(triaryl)amine (PTAA), on FA0.83MA0.17Pb(Br0.05I0.95)3 perovskite films. The HTLs are coated on perovskite film by altering the HTL's concentration and using F4-TCNQ and 4-tert-butylpyridine (tBP) and lithium bis(trifluoromethanesulfonyl)imide (LiTFSi) as dopants both for spiro-OMeTAD and PTAA. These HTLs diversified the charge concentration gradients in the absorption layer, thus leading to different recombination rates based on the employed laser intensities. At the same time, the generated charge carriers are rapidly transferred to the interface of the HTL/absorption layer and accumulate holes at the interface because of inefficient capacitance and mobility differences caused by differently doped HTL thicknesses. Notably, the charge concentration gradient is low at lower light intensities and did not accumulate holes at the HTL/absorption layer interface, even though they have high charge mobility. Therefore, this study highlights the importance of interfacial charge recombination and charge transport phenomena to achieve highly efficient and stable PSCs.

Impact of Photoluminescence Reabsorption in Metal‐Halide Perovskite Solar Cells

The Role of Photon Recycling in Perovskite Light-Emitting Diodes

Diffusion Effect on the Decay of Time-Resolved Photoluminescence under Low Illumination in Lead Halide Perovskites

Understanding Transient Photoluminescence in Halide Perovskite Layer Stacks and Solar Cells

Quantifying Non‐Radiative Recombination in Passivated Wide‐Bandgap Metal Halide Perovskites Using Absolute Photoluminescence Spectroscopy

Voltage-Dependent Photoluminescence and How It Correlates with the Fill Factor and Open-Circuit Voltage in Perovskite Solar Cells

Exploring the Charge Dynamics and Energy Loss in Printable Mesoscopic Perovskite Solar Cells

Effective Steady‐State Recombination Decay Times in Comparison to Time‐Resolved Photoluminescence Decay Times in Halide Perovskite Solar Cells

Synergy Between Dynamic Behavior of Hydrogen Defects and Non-Radiative Recombination in Metal-Halide Perovskites

Shallow defects and variable photoluminescence decay times up to 280 μs in triple-cation perovskites

Suppressing non-radiative recombination for efficient and stable perovskite solar cells

Elucidating Interfacial Hole Extraction and Recombination Kinetics in Perovskite Thin Films

Understanding Power‐Law Photoluminescence Decays and Bimolecular Recombination in Lead‐Halide Perovskites

Time-resolved photoluminescence on double graded Cu(In,Ga)Se2 - Impact of front surface recombination and its temperature dependence

Impact of Small Phonon Energies on the Charge-Carrier Lifetimes in Metal-Halide Perovskites

Understanding Performance Limiting Interfacial Recombination in pin Perovskite Solar Cells

Charge Carrier Recombination at Perovskite/Hole Transport Layer Interfaces Monitored by Time-Resolved Spectroscopy

Photon recycling in perovskite solar cells and its impact on device design

Revealing the internal luminescence quantum efficiency of perovskite films via accurate quantification of photon recycling

Role of surface recombination in perovskite solar cells at the interface of HTL/CH3NH3PbI3

Photoluminescence‐Based Characterization of Halide Perovskites for Photovoltaics