Abstract:Two microwave imaging chambers for breast cancer imaging are presented in this paper. The idea was to construct an imaging chamber that can be applied on one side of the breast of the patient. For this purpose, we reduced the size of the chamber (half of previous chamber) as present in [1], while making sure any size and volume of the breast can fit in it. The same bowtie antenna was used as in [1] because of several advantages such as easy to manufacture, fairly inexpensive, and extremely low profile. The antennas resonate at 2.6 GHz with return loss less than -15 dB in the chamber. The small size did not affect the performance of the antenna, such as s-parameters and radiation pattern, etc.. This imaging chamber consists of the six sides. Eighteen antennas were installed on the walls of the chamber (three antennas on each side of the chamber). High frequency structure simulator (HFSS) software is used in designing antenna and system models, as well as simulation with breast phantoms. A good agreement between simulated and measured S-parameters was observed. In order to check the performance of the modified imaging chamber, a water bottle is placed in the center of the chamber. The height of the target is 10cm, and the radius is 3cm. The back propagation method is used as the imaging algorithm. From reconstructing the image it can be seen that this imaging chamber has the capability of detecting smaller objects. In the second imaging chamber, a bowtie patch antenna with two sets of slots on the each side of the asymmetrical triangle patch, is used. The antenna resonates on dual frequencies of 2.4 GHz and 5.8 GHz. The return losses of the slotted bowtie antenna have almost the same matching level lower than -12 dB at 2.4 GHz and 5.8 GHz frequencies. The size of the antenna is 10 x 14.25mm (width x length). The flexible Taconic CER-10 (tm) material with a dielectric constant of 10 and a thickness of 1.52mm is used as the substrate of the antenna. The small size of the antenna can to a maximize number of antennas in the imaging chamber. The configuration of these two chambers will be discussed. And the performance of the slotted bowtie patch antenna will be presented, including its s-parameters, gain, radiation pattern and etc. The results show that this antenna is well suited in the bra shaped imaging chamber for medical application.

UWB Antenna with Enhanced Directivity for Applications in Microwave Medical Imaging

Low SAR Ultra Compact UWB Vivaldi Non-Uniform Slot Antennas for Breast Cancer Detection

Multilayered metamaterials array antenna based on artificial magnetic conductor's structure for the application diagnostic breast cancer detection with microwave imaging

Breast tumors detection using multistatic microwave imaging with antipodal Vivaldi antennas utilizing DMAS and it-DMAS techniques

An Ultra-Wideband Compact Planar Antenna for Wearable Microwave Medical Imaging Applications

Electromagnetic Performances Analysis of an Ultra-wideband and Flexible Material Antenna in Microwave Breast Imaging: To Implement A Wearable Medical Bra

Design and analysis of a super compact UWB antenna for accurate detection of breast tumors using monostatic radar‐based microwave imaging technique

Design and experimental validation of a metamaterial-based sensor for microwave imaging in breast, lung, and brain cancer detection

An Ultra-Wide Band MIMO Antenna System with Enhanced Isolation for Microwave Imaging Applications

Directional and isolated UWB‐MIMO antenna‐based uniplanar UWB‐FSS array and T‐strip for bi‐static microwave imaging: Baggage‐scanner

Development and comprehensive evaluation of a dual-port textile UWB MIMO antenna for biomedical use

Ultrawideband Textile Antenna for Wearable Microwave Medical Imaging Applications

Design and performance investigation of metamaterial-inspired dual band antenna for WBAN applications

A Microwave Imaging Chamber Using Bowtie Antennas for Biomedical Applications

Design of high gain miniaturized WPT rectenna for implantable biomedical applications

High Efficient and Ultra Wide Band Monopole Antenna for Microwave Imaging and Communication Applications

Compact and Ultra-Wideband Implantable MIMO Antenna for Deep Tissue Wireless Applications

Design and performance analysis of an L-shaped radiator and defected ground antenna for enhancing wireless connectivity in brain implants

Design and Analysis of a Low Profile Millimeter-Wave Band Vivaldi MIMO Antenna for Wearable WBAN Applications

A Novel Approach of a Low-Cost UWB Microwave Imaging System with High Resolution Based on SAR and a New Fast Reconstruction Algorithm for Early-Stage Breast Cancer Detection

Miniaturized Microwave Devices and Antennas for Wearable, Implantable and Wireless Applications