Abstract:Spray cooling, which has a fast thermal response and low flow rate consumption, is a common and effective thermal management approach for high power electronic systems. Typically, to improve the heat transfer co-efficient (HTC) for spray cooling, the target surface wettability is decreased, promoting nucleation boiling by reducing the surface energy barrier for bubble nucleation. However, the merging of bubbles and the formation of a vapor film have limitations in further increasing the critical heat flux (CHF). Hence, maximizing both the HTC and CHF of spray cooling can be mutually exclusive on the same heated surface. This paper presented a novel design for a vapor-liquid separation structure surface. It consisted of lower micropillars that serve as the vapor separation channel. On top of that, there was an upper multi-layer copper micromesh that wicks and spreads the coolant. Additionally, nano-grass attached to the micromesh to enhance capillary force and increase the nucleation sites simultaneously. Subsequently, we calculated the forward velocity and pressure drop of the droplets passing through the copper mesh to study the effects of droplet velocity and capillary force on heat transfer performance. The results show that the forward velocity of the droplets decreases rapidly as the increase of copper mesh layers and it drops to zero when passing through the third mesh. Therefore, the capillary force generated by the copper mesh is another important factor for the atomized droplets to pass through the copper mesh and reach the target surface. We have proven that all the vapor-liquid separation structure surfaces satisfy the condition Delta Pcap>Delta Ppore+Delta Plocal. Hence, the synergistic effects of the micropillar, copper micromesh, and nano-grass enable a circulation process of wicking-rewetting-vapor evacuation, which improves the onset of nucleate boiling (ONB), enhances the HTC, and increases the maximum heat flux dissipated by the system. Enhanced HTC (7.94 W/cm2/K) and maximum heat flux (817 W/cm2) were achieved at 1.50 ml/s on the vapor-liquid separation structure surfaces (#200 2-layer), representing an enhancement of 79.6% and 80.0% compared with that for the flat surface and the temperature of the heated surface at the ONB maximum decreased by approximately 30.8 degrees C.

Experimental investigation on the vectoring spray based on a novel synthetic jet actuator

Experimental Investigation of Spray Cooling Performance in Non‐boiling Zone on Rough Superhydrophilic/hydrophobic Surfaces

Experimental Study on a Spray and Falling-Film Cooling System

Piezoelectric Synthetic Jet Integrated with Heat Sink for Heat Transfer Enhancement

Investigation on a gas-atomized spray cooling upon flat and micro-structured surfaces

Experimental and computational investigation on synergistic enhancement spray cooling using micropillars and capillary-driven wicking hybrid structures

Quantitative investigation of the evaporation and resistance characteristics of inlet jet precooling

Experimental Investigation on the Thermal Performance of a Large-Size Aluminum Vapor Chamber for Multi-Point Heat Sources

An experimental investigation on heat transfer performance of electrostatic spraying used in machining

Experimental Study on Heat-Transfer Characteristics of Spray Cooling for Microchannel Radiators

Experimental Study of the Incidence of Changing a Synthetic Jet Orifice in Heat Transfer Using a Taguchi Method Approach

Characterization of dynamics and heat transfer in electro-spray at elevated flow rates

Coupling dynamic thermal analysis and surface modification to enhance heat dissipation of R410A spray cooling for high-power electronics

Spray Cooling on Enhanced Surfaces: A Review of the Progress and Mechanisms

Application status and prospect of spray cooling in electronics and energy conversion industries

Experimental study on heat transfer and power consumption of low-pressure spray cooling

Improving fluid flow and heat transfer of cryogen spray cooling using sweeping cold air jet

Experimental study of dielectric liquid spray cooling on multi-scale structured surfaces inspired by leaf veins

Development of Synthetic Jet Arrays for Heat Transfer Enhancement in Air-Cooled Heat Sinks for Electronics Cooling

Parametric study of water spray cooling on enhanced relatively large surfaces

The Coupling Effect of Surface Vibration and Micro-structure on Spray Cooling Heat Transfer