Seed‐Crystal‐Induced Cold Sintering Toward Metal Halide Transparent Ceramic Scintillators

Kai Han,Kostiantyn Sakhatskyi,Jiance Jin,Qinyuan Zhang,Maksym V. Kovalenko,Zhiguo Xia
DOI: https://doi.org/10.1002/adma.202110420
IF: 29.4
2022-03-25
Advanced Materials
Abstract:Scintillators with high spatial resolution at a low radiation dose rate are desirable for X-ray medical imaging. To challenge the state-of-art technology, it is necessary to design large-area wafers with high light yield, oriented light transport, and reduced light scattering. Here, a seed-crystal-induced cold sintering is adopted and a &lt;001&gt;-textured TPP<sub>2</sub> MnBr<sub>4</sub> (TPP: tetraphenylphosphonium) transparent ceramic is fabricated with a large-area wafer of 5 cm in diameter, exhibiting high optical transparency of above 68% over the 450-600 nm range. The compelling scintillation performance of the TPP<sub>2</sub> MnBr<sub>4</sub> wafer includes a light yield of ≈78 000 ± 2000 photons per MeV, a low detection limit 8.8 nanograys per second, about 625 times lower than the requirement of X-ray diagnostics (5500 nanograys per second), and an energy resolution of 17% for high-energy γ-rays (662 keV). X-ray imaging demonstrates a high spatial resolution of 15.7 lp mm<sup>-1</sup> . Moreover, the designed material exhibits good retention of the radioluminescence intensity and light yield. This work presents a paradigm for achieving light-guiding properties with high transparency and large-area fabrication by grain orientation engineering, and the transparent, textured metal halide ceramic scintillator is expected to provide a route for advancement in the X-ray imaging of tomorrow.
materials science, multidisciplinary,chemistry, physical,physics, applied, condensed matter,nanoscience & nanotechnology
What problem does this paper attempt to address?