Abstract:Accurate fault diagnosis is critical to the safe and reliable operation of the drilling pump. The challenge in fault diagnosis of the fluid end of the drilling pump is to extract the fault features more accurately. This paper proposes an innovative expansion operation to convert the one-dimensional (1D) signal into three-dimensional (3D) images with 3 channels, which not only increases the visibility of feature information but also reduces the influence of noise. To increase the identification types and improve the identification accuracy, this paper provides a Convolutional Neural Network (CNN) drilling pump fluid end fault diagnosis method based on the expansion operation. Firstly, to solve the problem that the feature information is not obvious in the 3D images, the expansion operation converts the 1D vibration signals into 3D images to generate images with more obvious features. Then, the AlexNet model is investigated by changing the number of neurons in the first fully connected layer. Compared to directly generated 3D images, grayscale images generated by Do’s method, and grayscale images generated by Do’s method combined with expansion operation, the diagnosis accuracy of the AlexNet model based on the 3D images generated by expansion operation is the highest. Finally, the experiment of the proposed fault diagnosis method of the fluid end of the drilling pump is carried out. Results show that the method proposed in this paper identifies 9 types of faults of the drilling pump’s fluid end with a mean accuracy of 98.00%, which is significantly higher than that of other diagnostic methods. This research provides a new approach to more accurately diagnose the drilling pump fluid end faults.

Fault diagnosis of electric submersible pumps using a three‐stage multi‐scale feature transformation combined with CNN‐SVM

Research on fault diagnosis of electric submersible pump based on improved convolutional neural network with Bayesian optimization

Fault Diagnosis of Hydraulic Components Based on Multi-Sensor Information Fusion Using Improved TSO-CNN-BiLSTM

Real-Time Fault Diagnosis for Hydraulic System Based on Multi-Sensor Convolutional Neural Network

A Rotating Machinery Fault Diagnosis Method Based on Multi-Sensor Fusion and ECA-CNN

Inter-turn short circuit and demagnetization fault diagnosis of ship PMSM based on multiscale residual dilated CNN and BiLSTM

Fault Diagnosis of Hydraulic System of Aircraft Landing Gear Based on CNN-SVM

A Novel Deep Learning Method for Intelligent Fault Diagnosis of Rotating Machinery Based on Improved CNN-SVM and Multichannel Data Fusion

CNN-Based Feature Fusion Motor Fault Diagnosis

Application of Multiscale Learning Neural Network Based on CNN in Bearing Fault Diagnosis

An improved convolutional neural network with an adaptable learning rate towards multi-signal fault diagnosis of hydraulic piston pump

A CNN model based on innovative expansion operation improving the fault diagnosis accuracy of drilling pump fluid end

Motor Fault Diagnosis Based on Short-time Fourier Transform and Convolutional Neural Network

Intelligent fault diagnosis of ultrasonic motors based on graph-regularized CNN-BiLSTM

Fault diagnosis of pump truck waterproof valves using multi-sensor high-dimensional time-domain feature expansion map

Multiscale Convolutional Neural Network With Feature Alignment for Bearing Fault Diagnosis

A High-Dimensional and Small-Sample Submersible Fault Detection Method Based on Feature Selection and Data Augmentation

Centrifugal Pump Fault Diagnosis Based on a Novel SobelEdge Scalogram and CNN

A digital twin-based fault diagnostic method for subsea control systems

Rolling Bearing Fault Diagnosis Using Multi-Sensor Data Fusion Based on 1D-CNN Model

Intelligent Fault Diagnosis of Hydraulic Piston Pump Based on Wavelet Analysis and Improved AlexNet