Low-Cost Efficient Magnetic Adsorbent for Phosphorus Removal from Water

Liting Zhang,Hongbing Dan,Orphe T. Bukasa,Linlin Song,Yin Liu,Liang Wang,Jianjun Li
DOI: https://doi.org/10.1021/acsomega.0c03657
IF: 4.1
2020-09-28
ACS Omega
Abstract:Adsorption using magnetic adsorbents makes the phosphorus removal from water simple and efficient. However, most of the reported magnetic adsorbents use chemically synthesized nanoparticles as magnetic cores, which are expensive and environmentally unfriendly. Replacing the nanomagnetic cores by cheap and green magnetic materials is essential for the wide application of this technique. In this paper, coal-fly-ash magnetic spheres (MSs) were processed to produce a cheap and eco-friendly magnetic core. A magnetic adsorbent, ZrO<sub>2</sub> coated ball-milled MS (<sub>2</sub>), was prepared through a simple chemical precipitation method. Careful structural investigations indicate that a multipore structural amorphous ZrO<sub>2</sub> layer has grown on the MS core. The specific surface area of <sub>2</sub> is 48 times larger than that of the MS core. The highest phosphorus adsorption is tested as 16.47 mg g<sup>–1</sup> at pH = 2. The <sub>2</sub> adsorbent has a saturation magnetization as high as 33.56 emu g<sup>–1</sup>, enabling efficient magnetic separation. Zeta potential measurements and X-ray photoelectron spectroscopy analysis reveal that the phosphorus adsorption of <sub>2</sub> is triggered by the electrostatic attraction and the ligand exchange mechanism. The <sub>2</sub> adsorbent could be reused several times after proper chemical treatment.This article has not yet been cited by other publications.
chemistry, multidisciplinary
What problem does this paper attempt to address?