A highly selective and sensitive electrochemical sensor for tetracycline resistant genes detection based on the non-covalent interaction of graphene oxide and nucleobase

Yi Xing,Yanan Zhang,Xiaolin Zhu,Chengzhi Wang,Tingting Zhang,Fangyuan Cheng,Jiao Qu,Willie J G M Peijnenburg,Willie J.G.M. Peijnenburg

DOI: https://doi.org/10.1016/j.scitotenv.2023.167615

IF: 9.8

2023-10-13

The Science of The Total Environment

Abstract:Antibiotic resistance genes (ARGs) are causing worldwide environmental problems, however, the traditional analytical methods and test equipment for them are time-consuming and expensive. The electrochemical sensor using the non-covalent bond between graphene oxide (GO) and single-stranded tet (ss- tet ) was established for specific tetracycline resistance genes ( tet , composed of ss- tet and complementary ss- tet (ss- tet ') in water) detection, which preparation time was only 35 min and far less than most reported sensors based on covalent bond. As the result of the detection for tet , the developed sensor not only had the low detection limit of 50.0 pM (8.1 × 10 2 copies·mL −1 ), the short detection time within 42 min, but also had satisfactory stability, excellent reproducibility, and highly selectivity (RSD < 4.43 %). Besides, it also had acceptable accuracy comparing to the real-time quantitative polymerase chain reaction (RT-qPCR) and PCR array in tet detection. Noticeably, it also had been successfully applied to tet A detection in different water samples. In brief, the prepared non-covalent bond sensor is simple, rapid, and suitable for highly selective and sensitive detection of the ARGs in actual water.

environmental sciences