Abstract:The increase of carrier frequency enables the utilization of the abundant high-frequency resource to meet the ceaseless demand for high data-rates. With respect to the transmitter, the design challenges include linear and high-efficiency PAs at high frequencies, low out-of-band (OOB) noise for frequency division duplex (FDD) applications, etc. Moreover, the integration of PAs on the CMOS die with other transmitter blocks greatly reduces the form factor and cuts down the cost. Among various linearization techniques, the Cartesian feedback architecture excels in its robustness against the process, voltage and temperature (PVT) variations as well as aging effects, but suffers from the noise-linearity trade-off caused by the feedback path [1]–[3]. To mitigate this issue, a Cartesian error-feedback architecture is proposed by adopting a reference path to cancel the signal before the feedback path and only leave the error information in principle. In this work, an $X -$band Cartesian error-feedback transmitter with a fully integrated power amplifier in bulk CMOS is implemented, and delivers maximum power $( \mathrm {P}_{SAT})$of 21.4dBm and output-referred 1dB compression point (OP $_{1dB})$of 21dBm. At $\mathrm {P}_{SAT}$and OP $_{1dB}$, the PA efficiency reaches 33.3% and 30.3%, with total system efficiency of 22.3% and 20.3%, respectively. Compared with the open-loop condition, the closed-loop transmitter demonstrates up to 13.6dB suppression of ACLR using WCDMA uplink (UL) signals, and improves EVM by over 6dB for 4Ms/s 64-QAM signals and over 3dB up to 16Ms/s signals. The out-of-band noise at 100MHz is -133/-131.8dBm/Hz for the lower and upper sidebands respectively.

A high-efficiency linear power amplifier for 28GHz mobile communications in 40nm CMOS

A High Linearity Class AB Power Amplifier for Sub-1 GHz Applications

28.8 A 21dBm-OP<inf>1dB</inf> 20.3%-Efficiency -131.8dBm/Hz-Noise X-Band Cartesian-Error-Feedback Transmitter with Fully Integrated Power Amplifier in 65nm CMOS

A 21dBm-OP1dB 20.3%-Efficiency-131.8dBm/Hz-Noise X-Band Cartesian-Error-Feedback Transmitter with Fully Integrated Power Amplifier in 65nm CMOS

A W-band current combined power amplifier with 14.8dBm Psat and 9.4% maximum PAE in 65nm CMOS

A 100–117 GHz W-Band CMOS Power Amplifier With On-Chip Adaptive Biasing

A Highly Linear 25dbm Outphasing Power Amplifier in 32nm CMOS for WLAN Application

A 2.45ghz CMOS Power Amplifier with High Linearity

A high efficiency 60GHz power amplifier in 90nm CMOS

25.2 A 19.7-to-43.8ghz Power Amplifier with Broadband Linearization Technique in 28nm Bulk CMOS

A 15.6 Dbm P, 24 Db Gain, 24.4%PAE, Linear CMOS Power Amplifier for 5G Application

A Highly Linear, Low Power, Highly Efficient, CMOS Wideband Power Amplifier for 2–5 GHz Wireless Communications

A Compact 19.7-to 43.8-Ghz Power Amplifier with 20.3-Dbm $p_{\mathrm{sat}}$ and 35.5% PAE in 28-Nm Bulk CMOS

A 2.4 GHz CMOS High Linear Power Amplifier

A 28-Ghz Power Amplifier with Enhanced Back-Off Efficiency Based on 65-Nm CMOS Process

A 53-to-73ghz Power Amplifier with 74.5mw/mm2 Output Power Density by 2D Differential Power Combining in 65nm CMOS

A Compact 140-Ghz CMOS Power Amplifier with 10.5-Dbm Output Power and 27.6-Db Power Gain Supporting Up to 128-QAM Modulation

A 68–79 GHZ 15.6DBM Power Amplifier in 65NM CMOS

A Highly Efficient 18–40 GHz Linear Power Amplifier in 40-nm GaN for mm-Wave 5G

A 1V 32.1 dBm 92-to-102GHz Power Amplifier with a Scalable 128-to-1 Power Combiner Achieving 15% Peak PAE in a 65nm Bulk CMOS Process.

A 57-64 GHz Two-Way Parallel-Combined Power Amplifier with 16.6 dBm Psat and 23.6% Peak PAE in 40nm Bulk CMOS