Abstract:Water-assisted injection molding (WAIM), a newly developed fluid-assisted injection molding technology has drawn more and more attentions for the energy saving, short cooling circle time and high quality of products. Existing research for the process of WAIM has shown that the pressure control of the injecting water is mostly important for the WAIM. However, the proportional pressure control for the WAIM system is quite complex due to the existence of nonlinearities in the water hydraulic system. In order to achieve better pressure control performance of the injecting water to meet the requirements of the WAIM, the proportional pressure control of the WAIM system is investigated both numerically and experimentally. A newly designed water hydraulic system for WAIM is first modeled in AMEsim environment, the load characteristics and the nonlinearities of water hydraulic system are both considered, then the main factors affecting the injecting pressure and load flow rate are extensively studied. Meanwhile, an open-loop model-based compensation control strategy is employed to regulate the water injection pressure and a feedback proportional integrator controller is further adopted to achieve better control performance. In order to verify the AMEsim simulation results WAIM experiment for particular Acrylonitrile Butadiene Styrene (ABS) parts is implemented and the measured experimental data including injecting pressure and flow rate results are compared with the simulation. The good coincidence between experiment and simulation shows that the AMEsim model is accurate, and the tracking performance of the load pressure indicates that the proposed control strategy is effective for the proportional pressure control of the nonlinear WAIM system. The proposed proportional pressure control strategy and the conclusions drawn from simulation and experiment contribute to the application of water hydraulic proportional control and WAIM technology.

Pressure control for pneumatic pressing roller in automated fiber placement

An Analytical Model for Pressure Distribution in Automated Fiber Placement on Irregular Surfaces and Its Application in Aeronautical Manufacturing

Compaction Pressure Distribution and Pressure Uniformity of Segmented Rollers for Automated Fiber Placement

Modeling and experimental validation of compaction pressure distribution for automated fiber placement

Modeling of Tension Control System with Passive Dancer Roll for Automated Fiber Placement

End-effector Contact Force Estimation for the Industrial Robot in Automated Fiber Placement Processes with Dynamic End-Load Variations

A New Fuzzy Self-Tuning Method for Controlling Packing Pressure of a High-Accuracy Injection Molding Machine

Measurement, Identification, and Compensation of Pose Errors for Six-Axis Gantry Automated Fiber Placement Machine

Pressure Distribution for Automated Fiber Placement and Design Optimization of Compaction Rollers

Process-dependent Wrinkle Formation for Steered Tow During Automated Fiber Placement: Modeling and Experimental Verification

Hybrid Position/Force Control for Dual-Machine Drilling and Riveting System

Proportional Pressure Control Of Water Hydraulic System For Water-Assisted Injection Molding: Modeling And Simulation

Continuous Stiffness Optimization of Mobile Robot in Automated Fiber Placement

Packing Pressure Control in a High-accuracy Plastic Injection Molding Machine Based on CMAC and PID Compound Controller

Modeling of contact mechanics and defects investigation in automated fiber placement

Deformation and Fracture Mechanisms of Automated Fiber Placement Pre-Preg Laminates under Out-of-plane Tensile Loading

Simulation and Experiment Research on the Proportional Pressure Control of Water-Assisted Injection Molding

A Planar Underactuated Compaction Mechanism with Self-Adaptability for Automated Fiber Placement Heads

Smart Roller: Soft Sensor Array for Automated Fiber Placement

Performance of 3D-Printed Continuous-Carbon-Fiber-Reinforced Plastics with Pressure