Sea water desalination using electrodialysis
Mohtada Sadrzadeh,Toraj Mohammadi
DOI: https://doi.org/10.1016/j.desal.2007.01.103
IF: 11.211
2008-03-01
Desalination
Abstract:Most widely applied and commercially proven desalination technologies fall into two categories of thermal (evaporative) and membrane based methods. Membrane methods are less energy intensive than thermal methods and since energy consumption directly affects the cost-effectiveness and feasibility of using desalination technologies membrane methods such as reverse osmosis (RO) and electrodialysis (ED), are attracted great attention lately. In this paper water desalination using a laboratory ED setup was described and evaluated. Taguchi method was initially used to plan a minimum number of experiments. A L9 orthogonal array (four factors in three levels) was employed to evaluate effects of temperature (at 25, 40, and 55°C), voltage (at 5, 7, and 9 V), flow rate (at 0.07, 0.13, and 0.25 mL/s) and feed concentration (at 10,000, 20,000, and 40,000 ppm) on separation percentage of salt ions. Maximum percentage of desalination was obtained at the lowest feed concentration and flow rate levels (10,000 ppm and 0.07 mL/s, respectively) and the highest voltage and temperature levels (9 V and 55°C, respectively). Analysis of variance (ANOVA) was applied to calculate sum of square, variance, ratio of factor variance to error variance and contribution percentage of each factor on response. The results showed that all factors have significant effect on the response. It was found that, feed concentration is the most influential factor on ED performance (its contribution percentage was calculated to be 82.4%). It was finally found that, contrary to the case of waste water treatment (concentrations of lower than 1000 ppm) which flow rate is the influential factor, in desalination of sea water (concentrations of upper than 10,000 ppm) feed concentration is the key parameter.
engineering, chemical,water resources