Abstract:We perform a Floquet stability analysis in the wake of a NACA0015 airfoil, with four angles of attack, α=20°, 17.5°, 15°, and 12.5°, considered. The central aim is to predict the secondary instabilities at the fixed moderate angles of attack, which are sufficiently large for massive separation from the airfoil, while at the same time allowing the formation and travelling of surface vortex on the airfoil, differentiating from the cases with very large angles of attack. We divide the angles of attack into two groups. We report that mode C is the first unstable mode for both groups, and which is also the only unstable mode for the small angles of attack, i.e., α=15° and α=12.5°, while for the high angles of attack, i.e., α=20° and α=17.5°, four unstable modes are observed. They are mode A, mode quasi-periodic, mode SL, and mode SS. The modes SL and SS are both subharmonic but with different wave numbers. We conjecture that these two subharmonic modes are resulted from the splitting of mode C. A comparison in the base flow topologies between the two groups shows that the different instability behaviors are probably due to their different flow patterns of the base flows. Three-dimensional direct numerical simulations (DNSs) have also been employed to study the physical realizability of the dominant unstable modes. A good consistency between the Floquet analysis and the 3D DNS results is achieved, indicating that the dominance of the linear instability is responsible for such a three-dimensional flow as the Reynolds number is not far from the critical value. Moreover, we find that the critical Reynolds numbers for the onset of three-dimensional instability fall into the range of 159.7–234.2 by defining this new Reynolds number according to the width of the flow wake. These values are very close to that of a bluff body. Furthermore, we note that the corresponding Strouhal numbers are around 0.17 for all the angles of attack, implying the relevance of three-dimensional instabilities to the wake dynamics or more specifically the fluctuation in the wake.

Koopman mode analysis on discovering distributed energy transfer of post-transient flutter of a bluff body

Laminar flow over a rectangular cylinder experiencing torsional flutter: Dynamic response, forces and coherence modes

Koopman analysis by the dynamic mode decomposition in wind engineering

An Efficient Coupled-Mode Flutter Analysis Method for Turbomachinery

Three-dimensional Transition after Wake Deflection Behind a Flapping Foil.

Insight into the intrinsic time-varying aerodynamic properties of a truss girder undergoing a flutter with subcritical Hopf bifurcation

Dynamic characteristic of transonic aeroelasticity affected by fluid mode in pre-buffet flow

Effect of Interaction of Flapping Hydrofoil Motion Parameters on Thrust Pulsation Performance

A novel multi-modal analytical method focusing on dynamic mechanism of bridge flutter

Koopman-inspired data-driven quantification of fluid–structure energy transfers

Numerical study on the nonlinear characteristics of shock induced two-dimensional panel flutter in inviscid flow

Mechanism of Single-mode Panel Flutter in Low Supersonic Flow

Floquet Stability Analysis in the Wake of a NACA0015 Airfoil at Post-Stall Angles of Attack

Performance of flapping airfoil propulsion with LBM method and DMD analysis

Dynamic mode decomposition analysis of the two-dimensional flow past two transversely in-phase oscillating cylinders in a tandem arrangement

Study of dynamics in post-transient flows using Koopman mode decomposition

External excitation effects on the flutter characteristics of a 2-DOF rigid rectangular panel

Koopman-based model predictive control with morphing surface: Regulating the flutter response of a foil with an active flap

Aeroelastic mode decomposition framework and mode selection mechanism in fluid-membrane interaction

Energy budget analysis and engineering modeling of post-flutter limit cycle oscillation of a bridge deck

Turbulence and flapping pivot axis effects on torsional flutter harvester efficiency by closed-form formula