A novel layered stack electromagnetic pump towards circulating metal fluid: Design, fabrication and test

Xu-Dong Zhang,Yi-Xin Zhou,Jing Liu

DOI: https://doi.org/10.1016/j.applthermaleng.2020.115610

IF: 6.4

2020-10-01

Applied Thermal Engineering

Abstract:<p>In this paper, a novel structure of electromagnetic pump to efficiently drive metal fluid was proposed, which can be called layered stack electromagnetic pump. Firstly, the coupled interaction mechanism of multi-physics fields was numerically interpreted, and the parameter optimizations of DC-EMP were systemically conducted. The optimization results show that inserting insulation bars can significantly reduce current dissipation by 69.7% in center line. And using closed iron yoke is beneficial to obtain a strong and uniform magnetic field. Moreover, the low flow duct is good to obtain a large pressure head. Based on the optimization results, a five layer structure of flow duct was provided. And a prototype was fabricated and tested. It shows that such pump can provide pressure head 120 kPa @ 300 A and maximum flow rate 6.9 L/min @300 A. It works smoothly and silently, and even, can operate steadily after two year intermittent operation. And this pump operation temperature was limited below 120 °C. Finally, the challenges unsolved and further optimization measures were suggested. Overall, the layered stack DC-EMP presented here enables liquid metal to be rather promising heat transfer fluid in advancing the field of extreme heat flux heat dissipation and thermal energy transportation.</p>

energy & fuels,engineering, mechanical,thermodynamics,mechanics

What problem does this paper attempt to address?

The problem that this paper attempts to solve is: how to design an efficient electromagnetic pump to drive the circulation of metallic fluids, especially in response to the requirements in liquid - metal cooling and heat - energy transfer applications. Specifically, the paper proposes a new type of layered - stacked direct - current electromagnetic pump (DC - EMP), aiming to improve the pump's pressure head, flow rate and efficiency by optimizing the electric field, magnetic field and flow - channel structure.

The following are the main problems and objectives of the paper:

1. **Deficiencies of traditional direct - current electromagnetic pumps**:
- Traditional direct - current electromagnetic pumps have problems such as current loss, magnetic flux density loss and an unreasonable flow - channel structure, resulting in limited performance.
- Especially in the low - power heat - management field (such as heat dissipation of electronic devices), the traditional structure is difficult to meet the requirements of efficient liquid - metal heat transfer.

2. **Core objectives of the paper**:
- Propose a design scheme for a new type of layered - stacked direct - current electromagnetic pump.
- Systematically optimize the electric field, magnetic field and flow - channel structure through numerical optimization methods.
- Verify the performance of the optimized electromagnetic pump in practical applications.

3. **Specific problems**:
- How to reduce current leakage and increase the effective current density?
- The paper significantly reduces the current dissipation on the center line (by about 69.7%) by inserting insulating strips to limit the current path.
- How to generate a strong and uniform magnetic field?
- Use a closed - yoke structure to reduce the magnetic flux density loss and ensure the uniformity of the magnetic field distribution.
- How to design the flow - channel to balance the pressure head and flow rate?
- Propose a five - layer - structured flow - channel design, which can obtain a large pressure head and avoid excessive hydraulic loss.

4. **Optimization results**:
- The maximum pressure head of the new - type electromagnetic pump prototype is 120 kPa (@300 A), and the maximum flow rate is 6.9 L/min (@300 A).
- The pump operates smoothly and quietly, and can still maintain stable performance after two years of intermittent operation.

In summary, the key problem that the paper attempts to solve is: improve the performance of the direct - current electromagnetic pump through optimized design, so that it can drive the flow of liquid metal more efficiently, and thus be applied to the fields of high - heat - flux heat dissipation and heat - energy transfer.