Phytochemical Composition and Antimicrobial Properties of New Lavandula angustifolia Ecotypes

Izabela Betlej,Bogusław Andres,Tomasz Cebulak,Ireneusz Kapusta,Maciej Balawejder,Natalia Żurek,Sławomir Jaworski,Agata Lange,Marta Kutwin,Elżbieta Pisulewska,Agnieszka Kidacka,Barbara Krochmal-Marczak,Piotr Boruszewski,Piotr Borysiuk

DOI: https://doi.org/10.3390/molecules29081740

IF: 4.6

2024-04-12

Molecules

Abstract:The purpose of this study was to characterize ethanol extracts from leaves and flowers of two ecotypes (PL—intended for industrial plantations and KC—intended for cut flowers) of Lavandula angustifolia Mill. The plant was cultivated in 2019 in southern Poland as part of a long-term research plan to develop new varieties resistant to difficult environmental conditions. The collected leaves and flowers were used to prepare ethanol extracts, which were then analyzed in terms of phytochemical composition and antioxidant, bactericidal, and fungicidal properties. Using UPLC techniques, 22 compounds belonging to phenolic acids and flavonoids were identified. UPLC test results indicated that ethanol extracts from leaves and flowers differ in phytochemical composition. Lower amounts of phenolic acids and flavonoids were identified in leaf extracts than in flower extracts. The predominant substances in the flower extracts were rosmarinic acid (829.68–1229.33 μg/g), ferulic acid glucoside III (810.97–980.55 μg/g), and ferulic acid glucoside II (789.30–885.06 μg/g). Ferulic acid glucoside II (3981.95–6561.19 μg/g), ferulic acid glucoside I (2349.46–5503.81 μg/g), and ferulic acid glucoside III (1303.84–2774.17 μg/g) contained the highest amounts in the ethanol extracts of the leaves. The following substances were present in the extracts in trace amounts or at low levels: apigenin, kaempferol, and caftaric acid. Leaf extracts of the PL ecotype quantitatively (μg/g) contained more phytochemicals than leaf extracts of the KC ecotype. The results obtained in this study indicate that antioxidant activity depends on the ecotype. Extracts from the PL ecotype have a better ability to eliminate free radicals than extracts from the KC ecotype. At the same time, it was found that the antioxidant activity (total phenolic content, ABTS•+, DPPH•, and FRAP) of PL ecotype leaf extracts was higher (24.49, 177.75, 164.88, and 89.10 μmol (TE)/g) than that determined in flower extracts (15.84, 125.05, 82.35, and 54.64 μmol (TE)/g). The test results confirmed that leaf and flower extracts, even at low concentrations (0.313–0.63%), significantly inhibit the growth of selected Gram-negative and Gram-positive bacteria and Candida yeasts. Inhibition of mold growth was observed at a dose extract of at least 1 mL/100 mL.

chemistry, multidisciplinary,biochemistry & molecular biology

What problem does this paper attempt to address?

The problem that this paper attempts to solve is to evaluate the phytochemical composition, antioxidant and antibacterial activities of ethanol extracts from the leaves and flowers of two lavender ecotypes (PL and KC). Specifically, the research aims are:

1. **Phytochemical component analysis**: Identify the phytochemical components in the ethanol extracts of the leaves and flowers of the two lavender ecotypes by UPLC technology, especially the contents of phenolic acids and flavonoids.
2. **Antioxidant activity evaluation**: Evaluate the antioxidant activities of different extracts by measuring the total phenolic content (TPC), ABTS free radical scavenging ability, DPPH free radical scavenging ability and ferric reducing antioxidant power (FRAP).
3. **Antibacterial activity test**: Test the growth - inhibiting effects of extracts at different concentrations on selected Gram - negative bacteria, Gram - positive bacteria and Candida.
4. **Antifungal activity test**: Evaluate the inhibitory effects of the extracts on the growth of molds, especially the effects at low concentrations.

These studies aim to provide information about the potential value of new lavender ecotypes in industrial cultivation and cut - flower uses, and explore their potential applications in the cosmetics and pharmaceutical industries.