Abstract:A solar tracker significantly increases the amount of energy harvested by a floating photovoltaic system by adjusting the pose of its photovoltaic (PV) panels to optimize their exposure to the solar rays. Conventional solar trackers perform such an adjustment using actuators, which is energy-consuming and involves complex structures. In this paper, a novel dual-axis wave-driven solar tracker is proposed where the photovoltaic (PV) panel is adjusted by the inertia force and gravity. Actuators are replaced by brakes to fix the pose of the PV panel. The kinematics and dynamics of the system are investigated, which are further used for the state feedback and the formulation of the control strategy. A sliding-mode observer is used to estimate the effect of winds on the system, which enables the robustness of the system to be enhanced. A motion planning strategy is also developed to track the solar position and minimize the movements of two joints. Indoor experiments are conducted to test the accuracy of the state feedback and dynamic model. The performance of the uncertainty observer is also tested by experiments. At last, field experiments on the real water surface are implemented to verify the feasibility of the proposed system. The results show that the solar tracker is able to adjust the PV panels at a velocity of 8.89 deg/s under the effect of limited base motions with amplitude less than 4°. Note to Practitioners—Traditional solar trackers can be driven passively by chemical energy or actively using actuators. The former cannot function stably in the field environment, and the latter is complex in structure and energy-consuming. For the FPV system under the effect of waves, the solar tracker can utilize the motion of the base to align its PV panel to the solar position. Thus, we present a wave-driven solar tracker without using actuators, and brakes are applied to lock the position of joints. The proposed solar tracker is ener- y-efficient, has a simpler structure and hardware than the active one, and is more robust than the passive one. We model the system and propose a control scheme to drive the PV panel using inertia and gravity. We also observe the effect of winds to enhance the system robustness. The motion planning strategy is investigated to minimize the movements of the joints. The impact of base motion and control period on the energy-harvesting efficiency is analyzed by simulations. Both indoor and field experiments are implemented to verify the feasibility of the system. The experimental results show that the system performs well even when the base shacking is less than 4°. Note that the control algorithm is a model-based algorithm, which means the model parameters (inertia, gravity, etc.) need to be reidentified for different PV panels and system properties. That is a challenge for large-scale deployment with different configurations. Future research will address the system identification problem and enable the model parameters to be updated automatically.

Experimental study on the interference effect of the wind-induced large torsional vibration of single-axis solar tracker arrays

Study on Dynamic Characteristics of the Ower-Foundation of 1.5 MW Wind Turbine

Experimental study on effect factors of wind-induced response of flexible photovoltaic support structure

Shielding and wind direction effects on wind-induced response of cable-supported photovoltaic array

Experimental Investigation on Wind-Induced Vibration of Photovoltaic Modules Supported by Suspension Cables

The Effect of Continuous Trapezoidal Straight Spoiler Plates on the Vortex-Induced Vibration of Wind Turbine Towers

Characterization of wake interference between two tandem offshore floating vertical-axis wind turbines: Effect of platform pitch motion

Wind load effect study on large-aperture parabolic trough collector mirror fields

Design and Control of a Wave-Driven Solar Tracker

Experimental studies on the effects of draft condition, current heading and mooring stiffness on vortex-induced motions of a Tension-Leg Platform

Computational Investigation of Wind Loads on Tilted Roof-Mounted Solar Array

Experimental Study on Thermally Induced Vibration of Flexible Solar Cell Wing Simulator

Experimental investigation of solidity and other characteristics on dual vertical axis wind turbines in an urban environment

Investigation into the Effect of Rounded Building Corner on Wind Loads of Flat-Roof-mounted Solar Arrays

Wind-induced response and control criterion of the double-layer cable support photovoltaic module system

Multi-degree-of-freedom vibration reduction strategy of the solar array drive system

Vortex-induced vibration control of a streamline box girder using the wake perturbation of horizontal axis micro-wind turbines

Investigation and control of vortex-induced vibration of twin box girders

Numerical Investigation of Effects of Turbulence Intensity on Aerodynamic Performance for Straight-Bladed Vertical-Axis Wind Turbines

Small Signal Modeling and Simulation for Torsional Vibration of Wind Farms