Abstract:The development of nanocomposite photocatalysts with high photocatalytic activity, cost-effectiveness, a simple preparation process, and scalability for practical applications is of great interest. In this study, nanocomposites of TiO2 Degussa P25 nanoparticles/activated carbon (TiO2/AC) were prepared at various mass ratios of (4:1), (3:2), (2:3), and (1:4) by a facile process involving manual mechanical pounding, ultrasonic-assisted mixing in an ethanol solution, paper filtration, and mild thermal annealing. The characterization methods included XRD, SEM-EDS, Raman, FTIR, XPS, and UV-Vis spectroscopies. The effects of TiO2/AC mass ratios on the structural, morphological, and photocatalytic properties were systematically studied in comparison with bare TiO2 and bare AC. TiO2 nanoparticles exhibited dominant anatase and minor rutile phases and a crystallite size of approximately 21 nm, while AC had XRD peaks of graphite and carbon and a crystallite size of 49 nm. The composites exhibited tight decoration of TiO2 nanoparticles on micron-/submicron AC particles, and uniform TiO2/AC composites were obtained, as evidenced by the uniform distribution of Ti, O, and C in an EDS mapping. Moreover, Raman spectra show the typical vibration modes of anatase TiO2 (e.g., E1g(1), B1g(1), Eg(3)) and carbon materials with D and G bands. The TiO2/AC with (4:1), (3:2), and (2:3) possessed higher reaction rate constants (k) in photocatalytic degradation of methylene blue (MB) than that of either TiO2 or AC. Among the investigated materials, TiO2/AC = 4:1 achieved the highest photocatalytic activity with a high k of 55.2 × 10−3 min−1 and an MB removal efficiency of 96.6% after 30 min of treatment under UV-Vis irradiation (120 mW/cm2). The enhanced photocatalytic activity for TiO2/AC is due to the synergistic effect of the high adsorption capability of AC and the high photocatalytic activity of TiO2. Furthermore, TiO2/AC promotes the separation of photoexcited electron/hole (e−/h+) pairs to reduce their recombination rate and thus enhance photocatalytic activity. The optimal TiO2/AC composite with a mass ratio of 4/1 is suggested for treating industrial or household wastewater with organic pollutants.

Facile synthesis of activated carbon/ZnFe2O4 hybrid composite as an efficient photocatalyst for enhanced degradation of methylene blue (MB) and reactive red 120 dye under UV light

Nanosized CuFe2O4/active carbon composite for efficient photocatalytic degradation towards organic dyes

Photocatalytic Degradation of Methylene Blue Using Zinc Oxide Nanorods Grown on Activated Carbon Fibers

Methylene Blue Dye Photocatalytic Degradation over Synthesised Fe3O4/AC/TiO2 Nano-Catalyst: Degradation and Reusability Studies

Facile Preparation Method of TiO2/Activated Carbon for Photocatalytic Degradation of Methylene Blue

Molecularly Imprinted Polymer-Based Photocatalyst for Highly Selective Degradation of Methylene Blue.

A novel photocatalytic degradation of mixed dye through chemically synthesized ZnO/Fe2O3 nanocomposite

Enhancing photocatalytic efficiency with Mn-doped ZnO composite carbon nanofibers for organic dye degradation

Enhanced photocatalytic activity of ZnO/g-C3N4 nanofibers constituting carbonaceous species under simulated sunlight for organic dye removal

Photocatalytic Degradation of Methylene Blue by ZnO/NiFe2O4 Nanoparticles

Facile synthesis of NiMn2O4/ZnMn2O4 heterostructure nanocomposite for visible-light-driven degradation of methylene blue dye

High photocatalytic efficiency of a ZnO nanoplate/Fe2O3 nanospindle hybrid using visible light for methylene blue degradation

Synergistic effect of modified pore and heterojunction of MOF-derived α-Fe2O3/ZnO for superior photocatalytic degradation of methylene blue

Engineering of a Hybrid g-C3N4/ZnO-W/Cox Heterojunction Photocatalyst for the Removal of Methylene Blue Dye

Facile synthesis of MnO2/g-C3N4 for photocatalytic reduction of methylene blue dye under visible light

Carbon/Mn3O4/SrTiO3 Microsphere Photocatalyst for the Efficient Removal of High-Concentration Methylene Blue from Water

Photocatalytic activity of ZnxCd0.8−xMn0.2Al0.1Fe1.9O4, (X = 0, 0.3) spinel ferrite for photodegradation of Congo red dye

Fabrication of Ni-Ac/Tio2 Composites and Their Photocatalytic Activity for Degradation of Methylene Blue

Fe-and-N co-doped Fe-ZIF-8-NH 2 (1/10) prepared by molecular-scale cages effect for highly efficient photocatalytic degradation of organic dyes

Zirconium and cerium dioxide fabricated activated carbon-based nanocomposites for enhanced adsorption and photocatalytic removal of methylene blue and tetracycline hydrochloride

Optimizing catalytic performance: Reduction of organic dyes using synthesized Fe 3 O 4 @AC magnetic nano-catalyst