Abstract:Considering the development of urban transportation systems and the importance of highway bridges in a city's resilience against earthquakes, it is critical to pay special attention to the seismic risk evaluation of highway bridges. The most significant issue to consider is the assessment of possible direct and indirect damages imposed on bridges before an earthquake. After this, the best practices for bridge rehabilitation can be adopted to minimize the induced damage. In this paper, we assessed the seismic risks associated with all 713 highway bridges in Tehran province (the capital of Iran). These bridges were initially divided into six categories according to their structural system and construction year and were also classified by whether or not seismic design was included. Among the 84,000 earthquakes recommended by the researchers' ten-thousand-year catalog, a set of 50 ground motion records was selected in the course of a probabilistic approach via the Optimization-based Probabilistic Scenarios (OPS) algorithm in an attempt to obtain the least amount of error compared to the original catalog in the final hazard curve in different regions of Tehran province. Afterward, the seismic fragility curves were plotted in four damage states of slight, moderate, extensive, and complete for the six bridge structural systems of simple, steel, concrete slab box, concrete slab–steel box, concrete slab, and steel girder–concrete slab. The results of the fragility curves extracted from the decision tree analysis were validated with those developed from incremental dynamic analysis (IDA) for a bridge case study modeled in the OpenSEES software V2.5.0. Later, using logical relationships, seismic risk curves were drawn for each structural system. The results show that, in general, the average seismic damage of bridges over ten years old is 0.88 times the average damage of bridges less than ten years old. The highest level of vulnerability is associated with the simple bridge system with a median vulnerability of 0.44. Moreover, the lowest level of vulnerability is related to the steel girder–concrete slab bridge system with a median vulnerability of 0.98, showing an increase of approximately 2.2 times in the median vulnerability. In addition, based on the sensitivity analysis results, the indirect and total risk levels increase almost exponentially with increasing the reconstruction index.

Probabilistic seismic demand of typical highway bridges in moderate-intensity zones

Seismic Response of Isolated Railway Bridge Subjected to Near-fault Ground Motion

Refined Probabilistic Seismic Demand Modeling of High-Speed Railway Bridge Under Near-Fault Hanging-Wall Effects and Velocity Pulse Effects by a Novel Ground Motion Selection Approach

Assessment of the Seismic Demands Posed to Suspension Bridges in the Near Field with Site-Specific Arrays of Simulated Ground Motions

Seismic performance assessment of highway bridge networks considering post-disaster traffic demand of a transportation system in emergency conditions

Enhancing Bridge Performance Following Earthquakes Using Markov Decision Process

An extended probabilistic demand model with optimal intensity measures for seismic performance characterization of isolated bridges under coupled horizontal and vertical motions

Optimum Life-Cycle Maintenance Strategies of Deteriorating Highway Bridges Subject to Seismic Hazard by a Hybrid Markov Decision Process Model

Dynamic behaviour of R/C highway bridges under the combined effect of vertical and horizontal earthquake motions

Assessment of bridge vulnerability due to seismic excitations considering wave passage effects

Stochastic Seismic Response Analysis of Long-span Continuous Rigid Frame Bridge

Improved probabilistic seismic demand-intensity relationship: heteroskedastic approachs

Probabilistic Pounding Analysis of High-Pier Continuous Rigid Frame Bridge with Actual Site Conditions

Optimal intensity measure selection and probabilistic seismic demand model of pile group supported bridges in sandy soil considering variable scour effects

Probability based seismic risk analysis of bridge structures

Probability Assessment of the Seismic Risk of Highway Bridges with Various Structural Systems (Case Study: Tehran City)

Extreme value distribution and dynamic reliability estimation of high-pier bridges subjected to near-fault impulsive ground motions

Lifetime seismic resilience of aging bridges and road networks

Response Characteristics of Irregular Continuous Rigid Frame Bridges with Long-Span and High-Rise Piers under Ground Motion Excitations with Different Fault Distances

Dynamic Responses of RC Girder Bridge under Heavy Truck and Seismic Loads Combined

Damage assessment of circular bridge pier incorporating high-strength steel reinforcement under near-fault ground motions