Abstract:ZnO nanorod arrays (NRAs) were fabricated on polyester fabrics (PFs) by a two-step method and modified with Ag by magnetron sputtering. The photogenerated charge transport properties of the Ag/ZnO nanorod heterojunctions were studied by a self-made Kelvin probe system and a surface photovoltage (SPV) test system. The measured work functions (WFs) of the deposited Ag and ZnO nanorod are 4.67 and 5.56 eV, respectively. The SPV spectra indicate that the direction of the inner electric field is from the Ag layer to the inner of the ZnO nanorod. The enhancement of light absorption by the local surface plasma resonance (LSPR) effect of Ag/ZnO NRA was observed by Raman microspectroscopy and UV–vis diffuse reflectance spectroscopy. The photocatalytic activity of the Ag/ZnO NRA-functionalized PFs was evaluated by the photocatalytic degradation of Rhodamine B (RB) solution under visible light. The full photo-oxidation of RB and the outperforming ZnO NRA-coated PFs demonstrate that the enhanced photocatalytic performance of Ag/ZnO NRA-coated PFs results from the cooperation of the inner electric field of the Ag/ZnO nanorod heterojunction and Ag LSPR.This article has not yet been cited by other publications.

What problem does this paper attempt to address?

The main problem that this paper attempts to solve is to improve the photocatalytic performance of ZnO nanorod arrays under visible light. Specifically, the authors prepared Ag - modified ZnO nanorod arrays (Ag/ZnO NRA) on polyester fabric and utilized the built - in electric field and the localized surface plasmon resonance effect (LSPR) to enhance their visible - light photocatalytic performance. The following are some key issues mentioned in the paper: 1. **Insufficient separation of photogenerated carriers**: - A single - layer ZnO has a low quantum yield due to the rapid recombination of photogenerated electrons and holes, thus affecting its photocatalytic performance. - ZnO has a relatively wide bandgap (about 3.2 eV), which limits its absorption of visible light and mainly concentrates in the ultraviolet region. 2. **Methods for improving photocatalytic activity**: - Separate photogenerated carriers by constructing heterojunctions (such as semiconductor - semiconductor or noble - metal - semiconductor). - Utilize the surface plasmon resonance effect of noble metals (such as Ag) to expand the light absorption range and improve photocatalytic activity. 3. **Material selection and preparation methods**: - Polyester fabric is selected as the substrate because it has the advantages of flexibility, good chemical stability and low cost. - Prepare ZnO nanorod arrays on polyester fabric by a two - step method and deposit an Ag layer by magnetron sputtering technology. 4. **Experimental verification**: - Evaluate the function of Ag/ZnO NRA by photocatalytically degrading Rhodamine B (RB) solution. - Use Kelvin probe system, surface photovoltage (SPV) test system, Raman microspectroscopy and UV - Vis diffuse reflectance spectroscopy to study the transport and separation mechanisms of photogenerated carriers. 5. **Mechanism discussion**: - The direction of the built - in electric field is from the Ag layer to the inside of the ZnO nanorods, which helps to effectively separate photogenerated electrons and holes. - The surface plasmon resonance effect of the Ag layer expands the light absorption range and improves the photocatalytic performance under visible light. In conclusion, this paper successfully solves the problem of poor photocatalytic performance of single - layer ZnO under visible light by preparing Ag/ZnO nanorod arrays on polyester fabric, showing its potential application value in water pollution treatment.

Ag-Modified ZnO Nanorod Array Fabricated on Polyester Fabric and Its Enhanced Visible-Light Photocatalytic Performance by a Built-in Electric Field and Plasmonic Effect