Abstract:The mandate assigned by the European Union to the Community Reference Laboratory for residues at the Istituto Superiore di Sanità covers, among other things, the assessment of trace elements in living animals as well as their products. To better protect the health of the consumer, this task aims in particular at harmonizing the procedures in use at the National Reference Laboratories (NRLs) for residues of the Member States for such determinations as well as at developing new approaches wherever the need arises. In this context an investigation was undertaken to appraise the average levels of a number of key elements in several types of honey with special regard to the influence of the various processing steps. Instrumental methods of election for the analysis of this matrix turned out to be inductively coupled plasma atomic emission spectrometry (ICP-AES) and inductively coupled plasma mass spectrometry (ICP-MS) depending on the actual concentrations of the elements of interest. Dissolution of the samples for suitable presentation to the analytical systems could be easily achieved by gentle heating at ca. 50 degrees C, sonication and addition of high-purity water. The ranges ascertained are as follows (in ng g(-1)): As, <0.50-0.70; Cd, <0.50-0.74; Cr, 1.03-3.93; Cu, 144-216; Fe, 191-651; Mn, 223-580; Ni, 17-49; Pb, 3.20-186; Pt, <0.50; Sn, <4-27; V, 1.22-1.94; and Zn, 565-1144. As a rule, concentrations of elements in honey from different beehives were similar. A few exceptions were noted for As, Cu, Fe, Ni and Zn. On the other hand, although data obtained with different analytical approaches for the same types of honey and beehive were generally in good agreement, yet some inconsistencies occurred, as in the case of Cu in freshly collected, extracted and ripened honey, Ni in extracted honey and Fe in ripened honey. These could not be traced back to specific procedural facts; rather, they should be ascribed to the inherent heterogeneity of the raw material. The experience gained with this exploratory study will be exploited to set up wider surveys and to plan the preparation of a new certified reference material in a matrix of honey to the benefit of NRLs for residues.

ESTABLISHMENT OF ANALYTICAL METHOD AND MONITORING FOR THE DETERMINATION OF SOME HEAVY METALS IN HONEY SAMPLES

Simultaneous Determination of Cd(II) and Pb(II) Ions in Honey and Milk Samples Using a Single-Walled Carbon Nanohorns Modified Screen-Printed Electrochemical Sensor.

Determination of some heavy metals in honey from different regions of Ethiopia

Trace Elements and Heavy Metal Contents in West Algerian Natural Honey

Assessment of selected heavy metals in honey samples using flame atomic absorption spectroscopy (FAAS), Ethiopia

The Bee honey as an Indicator to Environmental pollutions by Heavy metals in South Egypt, Egypt.

EFFECT OF LOCAL HONEY PRODUCTION AREAS ON ITS CONTENT OF SOME HEAVY METALS

Heavy Metal Accumulation and The Possible Correlation with Acetylcholinesterase Levels in Honey Bees from Polluted Areas of Alexandria, Egypt

Hydride Generation/Condensation System With an Inductively Coupled Argon Plasma Polychromator for Simultaneous Determination of Arsenic, Antimony, Selenium, Lead, Mercury and Tin in Honey

Development of salt-induced homogenous liquid-liquid extraction based on ternary deep eutectic solvent coupled with dispersive liquid-liquid microextraction for the determination of heavy metals in honey

Determination of Pesticides and Antibiotics in Honey by QuEChERS-HPLC-MS/MS

Study on the simultaneous determination of some essential and toxic trace elements in honey by multi-element graphite furnace atomic absorption spectrometry

Determination of essential and potentially toxic trace elements in honey by inductively coupled plasma-based techniques

Heavy Metals in Honey Collected from Contaminated Locations: A Case of Lithuania

A new synthesis, characterization and application chelating resin for determination of some trace metals in honey samples by FAAS

Honey as a sustainable indicator of heavy metals in tropical rainforest vegetation zone: an early warning monitoring approach

Development of Molecularly Imprinted Magnetic Amino Acid-Based Nanoparticles for Voltammetric Analysis of Lead Ions in Honey

Voltammetric determination of heavy metals in honey bee venom using hanging mercury drop electrode and PLA/carbon conductive filament for 3D printer

Honey Bee Products as Bio Indicator of Heavy Metals Pollution and Health Risk Assessment Through the Consumption of Multifloral Honey Collected in Azad Kashmir, Pakistan

An Analytical Method for the Biomonitoring of Mercury in Bees and Beehive Products by Cold Vapor Atomic Fluorescence Spectrometry

Levels and health risk assessment of trace metals in honey from different districts of Bench Sheko Zone, Southwest Ethiopia