Oxygen Vacancies Engineering–Mediated BiOBr Atomic Layers for Boosting Visible Light‐Driven Photocatalytic CO 2 Reduction

Lin Wang,Gaopeng Liu,Bin Wang,Xin Chen,Chongtai Wang,Zixia Lin,Jiexiang Xia,Huaming Li

DOI: https://doi.org/10.1002/solr.202000480

IF: 9.1726

2020-12-13

Solar RRL

Abstract:<p>CO₂ photoreduction into valuable chemicals is a sustainable and prospective technology to alleviate greenhouse effect and the energy crisis. However, the photocatalytic efficiency is impeded by undesirable recombination of photogenerated carrier and poor CO₂ activation performance. In this work, oxygen vacancies are introduced into BiOBr atomic layers by ultraviolet light assisting to increase the efficiency of carrier separation and CO₂ adsorption‐activation performance, enhancing the CO₂ reduction activity. The introduction of oxygen vacancies could effectively enhance the visible light absorption, boost the photogenerated carrier separation migration and tune the adsorption/desorption process for CO₂ and products on the surface of photocatalyst. The optimized oxygen vacancies engineering mediated photocatalyst achieves a high CO generation rate of 10.15 µmol g⁻¹ under visible light irradiation for 5 h in pure water, which is 1.99 times compared to that of pristine BiOBr atomic layers. The possible photocatalytic mechanism was investigated by <i>in situ</i> FT‐IR spectrometry. This work offers an opportunity to design oxygen vacancies‐rich ultrathin semiconductors for high‐performance CO₂ reduction.</p><p>This article is protected by copyright. All rights reserved.</p>

energy & fuels,materials science, multidisciplinary

What problem does this paper attempt to address?

### Problems Addressed by the Paper

The paper primarily aims to address the following issues:

1. **Low Efficiency of Photocatalytic CO₂ Reduction**:
- High recombination rate of photogenerated carriers (electrons and holes), leading to ineffective participation of photogenerated charges in CO₂ reduction reactions.
- Weak visible light absorption capability of semiconductor materials, resulting in most solar energy being unused.

2. **Difficulty in CO₂ Adsorption and Activation**:
- In heterogeneous photocatalytic systems, it is challenging for the catalyst surface to adsorb CO₂.
- The C=O bond in CO₂ molecules has a very high bond energy (750 kJ/mol), making it difficult to activate the adsorbed CO₂.

To overcome the above issues, researchers optimized the performance of bismuth oxybromide (BiOBr) atomic layers by introducing oxygen vacancies (OVs). Specifically, oxygen vacancies introduced by UV light irradiation can enhance visible light absorption, improve the separation efficiency of photogenerated carriers, and enhance CO₂ adsorption and activation performance. Experimental results show that the optimized oxygen vacancy-rich BiOBr atomic layers exhibit a higher CO generation rate (10.15 μmol g⁻¹) in pure water, which is 1.99 times higher than that of the original BiOBr.

In summary, the paper aims to enhance the efficiency and stability of photocatalytic CO₂ reduction by designing and preparing ultrathin semiconductor materials rich in oxygen vacancies.