Abstract:In this study, we evaluated the use of prickly pear seed cake, a by-product of prickly pear seed oil extraction, as a new precursor for producing activated carbon by phosphoric acid activation, and the obtained carbon’s capacity for heavy metal removal from aqueous solution. Response surface methodology based on the full factorial design at two levels (24) was developed to reduce the number of experiments and reach optimal preparation conditions for the removal of cadmium and lead ions from aqueous solutions. Design Expert 11.1.2.0 Trial software was used for generating the statistical experimental design and analyzing the observed data. Factors influencing the activation process, such as carbonization temperature, activation temperature, activation time, and impregnation ratio, were studied. Responses were studied in depth with an analysis of variance to estimate their significance. Each response was outlined by a first-order regression equation demonstrating satisfactory correspondence between the predicted and experimental results as the adjusted coefficients of correlation. Based on the statistical data, the best conditions for the removal of heavy metals from aqueous solution by the obtained activated carbon were indicated. The maximum iodine number and methylene blue index were 2527.3 mg g−1 and 396.5 mg g−1, respectively, using activated carbon obtained at the following conditions: Tc = 500 °C, Ta = 500 °C, impregnation ratio = 2:1 (g H3PO4: g carbon), and activation time of two hours. The maximum adsorption reached 170.2 mg g−1 and 158.4 mg g−1 for Cd2+ and Pb2+, respectively, using activated carbon obtained at the following conditions: Tc = 600 °C, Ta = 400 °C, impregnation ratio = 2:1 (g H3PO4: g carbon), and activation time of one hour. The activated carbon obtained was characterized by Boehm titration, pH of point of zero charge (pHPZC), Brunauer–Emmett–Teller surface area (SBET), and scanning electron microscopy. Adsorption was performed according to different parameters: pH solution, adsorbent dosage, temperature, contact time, and initial concentration. Regeneration experiments proved that the obtained activated carbon still had a high removal capacity for Cd2+ and Pb2+ after five regeneration cycles.

Characterization and use of activated carbon synthesized from sunflower seed shell in the removal of Pb(II), Cd(II), and Cr(III) ions from aqueous solution

Optimization of the Preparation of Activated Carbon from Prickly Pear Seed Cake for the Removal of Lead and Cadmium Ions from Aqueous Solution

Highly Porous Carbon Materials Prepared Through KOH‐Assisted CO2‐Activation of Carbonized Waste Tires for Removal of Cr(VI) and Cd(II) from Water

Adsorption of Pb, Cu, and Ni Ions on Activated Carbon Prepared from Oak Cupules: Kinetics and Thermodynamics Studies

Preparation and Characterization of Nanoporous Activated Carbon Derived from Prawn Shell and Its Application for Removal of Heavy Metal Ions

High surface area microporous activated carbon from Pisum sativum peels for hexavalent chromium removal from aquatic environment

Inclusive study of peanut shells derived activated carbon as an adsorbent for removal of lead and methylene blue from water

Chemically Activated Carbon Based on Biomass for Adsorption of Fe(III) and Mn(II) Ions from Aqueous Solution

Nitrogen- and oxygen-doped carbon particles produced from almond shells by hydrothermal method for efficient Pb(II) and Cd(II) adsorption

Microporous nano-activated carbon type I derived from orange peel and its application for Cr(VI) removal from aquatic environment

The Treatment of Cadmium-contained Wastewater Using Activated Carbon Prepared from Anaerobic Digested Residue of S.alterniflora

Comparative Study on the Adsorption Characteristics of Heavy Metal Ions by Activated Carbon and Selected Natural Adsorbents

Effective removal of heavy metals from aqueous solutions using activated biomass: Analytical interpretation via molecular dynamic simulation, mathematical and statistical approaches

Adsorption isotherms and removal of lead (II) and cadmium (II) from aqueous media using nanobiochar and rice husk

Removal of Heavy Metal Ions (Pb2+, Co2+, and Cd2+) by Activated Carbon from Cypress Fruit: An Investigation of Kinetics, Thermodynamics, and Isotherms

Performance and optimization of diclofenac and ibuprofen adsorption onto activated carbon synthesized from sunflower seed shell (Helianthus annuus) in natural groundwater samples

Peanut Shell Activated Carbon: Characterization, Surface Modification and Adsorption of Pb2+ from Aqueous Solution

Phosphorus and oxygen co-doped carbon particles based on almond shells with hydrothermal and microwave irradiation process for adsorption of lead (II) and cadmium (II)

Equilibrium and kinetic studies on adsorption of chromium(VI) onto pine-needle-generated activated carbon

Kinetic, equilibrium isotherm and thermodynamic studies of Cr(VI) adsorption onto low-cost adsorbent developed from peanut shell activated with phosphoric acid

Fabrication of thiosemicarbazide-modified biochar/carrageenan composite beads based on Eichhornia crassipes for effective removal of Pb (II) from aqueous medium