Abstract:The low-frequency content of seismic waves in exploration is of substantial value as it can benefit imaging and inversion by providing deeper penetration, broader-band energy, and wavelet stability. However, characterizing the factors contributing to low frequencies (the seismic source, response of the receiver, and spectral signal-to-noise) and their effects may be complicated. The Hussar, Alberta survey, conducted by the CREWES Project at the University of Calgary and used here, addresses this challenge with a range of sources and receiver types. We further analyze the low-frequency content of the Hussar data using surface waves - because of their significant coherent low-frequency energy. The multichannel analysis of surface waves (MASW) method is used. To improve accuracy, a nonlinear approach is applied to extract dispersion properties, overcoming the limitations of conventional methods at low frequencies. This allows for precise phase velocity measurements across frequencies and assesses the frequency content of different source-receiver type combinations based on surface-wave coherence. The extracted dispersion properties were validated by comparing the dispersion curves estimated using Vs from traveltime tomography and well-logging data. The survey tested 2 kg dynamite in addition to vibroseis sources with low-dwell and linear sweeps. The receivers evaluated included Vectorseis accelerometers, as well as 10 and 4.5 Hz geophones. Our dispersion results indicate that all source-receiver combinations contain considerable surface-wave energy down to about 2 Hz. The inverted 1-D Vs models provide Vs estimates to about 800 m, consistent with results from S-wave tomography and shear logging. Dynamite produced more low-frequency energy in surface waves than vibroseis sources, extending below 1.5 Hz. Low-dwell sweeps showed clearer coherence in surface waves at low frequencies than linear sweeps. Of the receivers tested, the 4.5 Hz geophone showed higher sensitivity to low frequencies than both the Vectorseis accelerometer and the 10 Hz geophone. Although the Vectorseis accelerometer recorded more coherent low-frequency surface waves than the 10 Hz geophone, its signals were affected by some instrument noise. Analyzing surface-wave energy and coherency to assess low-frequency content can complement other types of spectral analysis.

Coherence-based approaches for estimating the composition of the seismic wavefield

Wiener filtering with a seismic underground array at the Sanford Underground Research Facility

Low coherency of wind induced seismic noise: Implications for gravitational wave detection

Study Of Extracting Group Velocities Of Near-Surface Rayleigh Waves From Ambient Noise

Retrieval of Amplitude and Attenuation from Ambient Seismic Noise: Synthetic Data and Practical Considerations

Application of Temporal Reweighting to Ambient Noise Cross-Correlation for Improved Seismic Green's Function

Comparing the low-frequency content of exploration seismic source - receiver combinations using surface waves: a field study in Hussar, Alberta

Application of Six-Component Ambient Seismic Noise Data for High-Resolution Imaging of Lateral Heterogeneities

Seismic interferometry from correlated noise sources

A Frequency-Domain Beamforming Procedure for Extracting Rayleigh Wave Attenuation Coefficients and Small-Strain Damping Ratio from 2D Ambient Noise Array Measurements

Seismic Anisotropy From 6C Ground Motions of Ambient Seismic Noise

Estimation of Surface Wave Green's Functions from Correlation of Direct Waves, Coda Waves, and Ambient Noise in SE Tibet

Rayleigh wave attenuation tomography based on ambient noise interferometry: methods and an application to Northeast China

Coherence attribute applications on seismic data in various guises — Part 2

Evaluating Diffuse Wavefield and Its Applications in Seismic Imaging

High-Resolution Ambient Noise Imaging of Geothermal Reservoir Using 3C Dense Seismic Nodal Array and Ultra-Short Observation

Seismic Interferometry With Very Short Ambient Seismic Noise Recording

Reconstruction of Subsurface Structure from Ambient Seismic Noise: an Example from Ketzin, Germany

Estimation of Wavelet Coherence of Seismic Ground Motions

Analysis of the vertical structure of deep ocean noise using measurements from the SPICEX and PhilSea experiments

Using Surface Waves Recorded by a Large Mesh of Three-Element Arrays to Detect and Locate Disparate Seismic Sources