Tribological Behaviour of Austenitic Stainless Steel-Clad Surface Over Low Carbon Steel Produced by Cold Metal Transfer Welding Process

Varsha Mishra,N. Yuvaraj,Vipin

DOI: https://doi.org/10.1007/s12666-024-03261-8

2024-02-20

Transactions of the Indian Institute of Metals

Abstract:Low carbon steel has become an in-demand material in various industrial applications due to its versatility and cost-effectiveness. Despite its unparalleled advantages, it cannot be utilized in wear-resistant applications without surface alteration, which can be achieved by cladding stainless steel over low carbon steel. This study aims to clad 308L stainless steel over a low carbon steel plate using the cold metal transfer (CMT) welding process at different welding speeds (3, 4, 5, and 6 mm/sec). A ball-on-disc reciprocating tribometer was used to examine the wear characteristics of the cladding surface by varying the normal loads (30N, 40N and 50N) and frequencies (5 Hz, 10 Hz and 15 Hz). The wear resistance of the cladding surface is enhanced by 30–40% compared to a base material. Results show that the wear rate varies with the applied load and frequency. Due to the metastability of austenitic stainless steel during plastic deformation, the austenite changes into martensite. The cladding and worn-out surfaces were examined through optical and field emission scanning electron microscopy (FESEM) to study the wear mechanisms.

metallurgy & metallurgical engineering