Abstract:Catalytic hydrogenation of furfural (FFL) to furfuryl alcohol (FAL) is one of the pivotal reactions for biomass valorization. Herein, well-defined Cu nanoparticles of ∼1.8 nm encapsulated within titanium silicalite-1 (TS-1) have been successfully prepared by an in situ encapsulation approach, which possesses significant advantages in metal dispersion and uniformity compared to the traditional wet impregnation method. After a Na ion-exchange process for modulation of the zeolite microenvironment, the obtained Na– catalyst affords an enhanced activity and selectivity in the selective hydrogenation of FFL into FAL, with a FFL conversion of 93.0% and a FAL selectivity of 98.1% at 110 °C, 10 bar H2, after a reaction time of 2 h. A turnover frequency value of 55.2 h–1 has been achieved, reflecting some of the highest activity for Cu-based heterogeneous catalysts under similar conditions. Comprehensive characterization studies reveal that the confined environment of the zeolite could not only provide the spatial restriction for metal particles but also induce an electronic interaction between encapsulated Cu nanoparticles and Ti species in Na–, which both lead to effective suppression of the metal aggregation and leaching during catalysis. Na species, added by the ion exchange, not only mediate the acid/basic property of the zeolite for suppressing the side reactions but also modulate the encapsulated Cu species into an electronic-rich state, facilitating the FFL hydrogenation. Deactivation of Na– is primarily caused by Na leaching into the liquid phase, but activity can be almost restored after a Na readdition process.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acscatal.1c02658.Synthesis of Cu/TS-1, Na–Cu/TS-1, , and Na– catalysts, catalyst characterization procedure and catalytic testing procedure in the hydrogenation of FFL; N2 physisorption data; STEM, catalytic data, XRD, UV–vis DR, TG analysis, NH3–TPD, FT-IR-Py, CO2–TPD, EXAFS, FT-IR, FT-IR-CO, and XPS characterizations (PDF)This article has not yet been cited by other publications.

Nb-Based Catalysts for the Valorization of Furfural into Valuable Product through in One-Pot Reaction

Selective Hydrogenation of Furfural to Furfuryl Alcohol Without External Hydrogen over N-doped Carbon Confined Co Catalysts

Encapsulation of CuO Nanoparticles Within Silicalite-1 As a Regenerative Catalyst for Transfer Hydrogenation of Furfural

Pt/Nb2O5-Al2O3 Catalysts for the Hydrogenation and Reductive Amination of Furfural

Catalytic Conversion of Furfural to Methyl Levulinate in a Single-Step Route over Zr/SBA-15 in Near-Critical Methanol

Chemical valorisation of biomass derived furanics and carboxylic acids over niobium-based catalysts

Zr-doped phosphorus-containing activating carbons catalysts for the valorization of furfural into valuables products in one-pot reaction

Single-Step Formation of Metal Oxide Nanostructures Wrapped in Mesoporous Silica and Silica–Niobia Catalysts for the Condensation of Furfural with Acetone

Pd/Nbopo4 Multifunctional Catalyst for the Direct Production of Liquid Alkanes from Aldol Adducts of Furans

Zeolite-Encapsulated Cu Nanoparticles for the Selective Hydrogenation of Furfural to Furfuryl Alcohol

Ni supported on sepiolite catalysts for the hydrogenation of furfural to value-added chemicals: influence of the synthesis method on the catalytic performance

Zr supported on non-acidic sepiolite for the efficient one-pot transformation of furfural into γ-valerolactone

Conversion of Xylose into Furfural over MC-SnOx and NaCl Catalysts in a Biphasic System

Two-dimensional MXenes As Catalytic "flying Carpets" to Transport Biomass Valorization Towards New Horizons: the Case of Furfural Catalytic Transfer Hydrogenation over Noble-Metal Free Niobium-Based Carbides

Nanoporous Cu–Al–Co Alloys for Selective Furfural Hydrodeoxygenation to 2-Methylfuran

Exploration on Hydroxymethylation of Furfural to 5-Hydroxymethylfurfural Over Mesoporous Niobium Phosphate Catalyst

5-Hydroxymethylfurfural Oxidation to 2,5-Furandicarboxylic Acid on Noble Metal-Free Nanocrystalline Mixed Oxide Catalysts

Catalytic production of γ-valerolactone, a biofuel precursor, from furfural in one-pot: Synergistic effect between Zr and Sn

Catalytic one-pot conversion of biomass-derived furfural to ethyl levulinate over bifunctional Nb/Ni@OMC

Highly Efficient Nb2O5 Catalyst for Aldol Condensation of Biomass-Derived Carbonyl Molecules to Fuel Precursors

Valorization of Furfural to Obtain High Value-Added Products with ZrO2- and Al2O3-Pillared Clays