Abstract:Lithium-ion batteries have been widely used in electric vehicles and electrochemical energy storage power stations. With the increase of service time, the single cells in the battery module will age to varying degrees, resulting in inhomogeneous heat generation and even safety accidents. Considering that there is currently limited research on the cooling effect of battery cooling technology on aging batteries, this article adopts a new non-destructive method to study the uneven aging characteristics and the temperature rise characteristics under different cooling conditions of different cells in small aging lithium-ion battery modules. The results show that the irreversible heat generation power of cell 1, cell 2 and cell 3 during 1C discharge is 1.23 W, 1.33 W and 1.15 W, respectively, showing different degrees of aging. However, the maximum temperature rise under natural heat dissipation conditions has the same change trend and the average temperature rise on the surface of three cells at the end of discharge is about 20 °C. The temperature rise at the edge of cell 2 and cell 1 with more serious aging is higher, while the temperature rise at the center of cell 3 with the smallest aging degree is higher. The temperature distribution at different positions on the surface of the three cells was slightly different. The maximum temperature difference at different positions on the surface of cell 2 (2.3 °C) was greater than that of cell 1 (1.5 °C) and cell 3 (1.6 °C). Then, a simple OCV test method and SEM characterization technique were used to analyze the aging characteristics of the electrode position corresponding to the external temperature monitoring position of cell 2, and the relationship between temperature distribution and aging characteristics was established. The cooling and uniform temperature ability of thermal pad, semiconductor cooling and liquid cooling plate/semiconductor composite cooling are improved in turn. Among them, the liquid cooling plate/semiconductor composite cooling is an efficient temperature control strategy which can make the temperature of cell 3 basically stable at 23 °C during 1C discharge by reasonably regulating the cooling power, and the maximum surface temperature difference is maintained at 0.4 °C. It is suggested that when the large cell is put into use, it should be equipped with an independent sub-regional precise temperature control system that can adjust the cooling power in real time according to the heat production rate of the battery, so as to improve the safety and promote the development of sustainable energy.

Experimental study on lithium-ion cell characteristics at different discharge rates

Impact of Low Temperature Exposure on Lithium-Ion Batteries: A Multi-Scale Study of Performance Degradation, Predictive Signals and Underlying Mechanisms

Effects of Different Charging and Discharging Modes on Thermal Behavior of Lithium Ion Batteries

Study on cycling performance of lithium iron phosphate battery at different discharge rates

Experimental Study on Influence of Temperature and C-Rate of Discharge on Performance of In-House-Fabricated 30-Ah Li-Ion Prismatic Cell Made With Lithium Iron Phosphate and MCMB

Experimental Study on Electrical Properties of Power Lithium-ion Battery

Experimental study on the effect of ambient temperature and discharge rate on the temperature field of prismatic batteries

Degradation and safety performance of lithium-ion cells under high-rate charging/discharging scenarios

Thermal characteristics of ultrahigh power density lithium-ion battery

Lithium-ion battery discharge behaviors at low temperatures and cell-to-cell uniformity

Numerical Study on Thermal Characteristics Comparison Between Charge and Discharge Process for Lithium Ion Battery

Thermal behavior analysis of lithium-ion capacitors at transient high discharge rates

The Influence of Temperature on the Capacity of Lithium Ion Batteries with Different Anodes

Study on Thermal Safety of the Overcharged Lithium-Ion Battery

The Thermal Response of Lithium Titanate Battery During Pulse Discharge

Study on the temperature rise characteristics of aging lithium-ion batteries under different cooling methods

Hazardous characteristics of charge and discharge of lithium-ion batteries under adiabatic environment and hot environment

Impact of low temperature and charge profile on the aging of lithium-ion battery: Non-invasive and post-mortem analysis

Experimental investigations on the correlations between the structure and thermal‐electrochemical properties of over‐discharged ternary/ Si‐C power batteries

Thermal simulation and prediction of high-energy LiNi0.8Co0.15Al0.05O2//Si-C pouch battery during rapid discharging

Experimental and Simulation Studies on the Thermal Characteristics of Large‐Capacity Square Lithium‐Ion Batteries with Low‐Temperature Discharge