Wideband Fixed-Beam Single-Piece Leaky-Wave Antenna with Controlled Dispersion Slope

Shu-Lin Chen,Li-Zhao Song,Debabrata K. Karmokar,Bevan Jones,Y. Jay Guo

DOI: https://doi.org/10.1109/tap.2023.3310005

IF: 5.7

2023-01-01

IEEE Transactions on Antennas and Propagation

Abstract:Leaky wave antennas (LWAs) have been widely investigated for wireless systems because of their simple feed, low profile, and easy integration. They typically have a dispersive traveling wave leading to beam squinting behavior, which can significantly decrease the useful operating bandwidth in point-to-point communications. An innovative method that avoids beam squint with frequency over a wide band is developed in this work using a negative dispersion slope. By integrating a baffle of square bracket-shaped metal pieces into a transverse-slot LWA, the main beam angle is almost fixed at an angle, $\theta = 37^{\circ } \pm 2^{\circ }$ , across a wide frequency band from 9.5 to 12.2 GHz. The wide bandwidth is a consequence of the negative dispersion slope produced by the interaction between the baffle and the slotted waveguide. In the $\theta = 37^{\circ }$ direction, the gain variation is less than 3 dB across this band. Equivalent circuit analysis and full-wave modeling are presented to demonstrate the negative-slope dispersion diagram. The obtained 3-dB gain curve exhibits a filter characteristic. In addition, the bandwidth can be chosen by a suitable selection of parameters. It is the first time that these desirable features have been reported for wideband fixed-beam LWAs. The final antenna was fabricated with a low-cost additive manufacturing (3-D printing) technology. The measured results agree well with the simulated ones and verify the effectiveness of the antennas developed in this way.

telecommunications,engineering, electrical & electronic