Abstract:<p>3D micro-scale model of fibrous media with controllable structural parameters (such as fiber diameter, solid volume fraction and cell configuration) was constructed by using Voronoi algorithm in this study. Compared with the fibrous media model having layer-structured topology, the Voronoi-based model can well characterize the penetration behavior between fibers and layer connections. The gas–solid flow characteristics in fibrous media under different structural and operating parameters were examined numerically and semi-analytically. The results show that the pressure drop of fibrous media between numerical results and experimental values in literature is not always consistent. A new pressure drop correlation for fibrous media is proposed. Additionally, numerical results of the filtration efficiency show similar tendencies to the results that are calculated by the semi-analytical model. For submicron particles, the Stokes-Cunningham drag law combined with Saffman's lift force and Brownian force can accurately predict the capture action dominated by the combination of diffusion and inertia. The deviation of filtration efficiencies between numerical results and theoretical predictions increases with increase of the Peclet number. For micron particles, the semi-analytical model-determined filtration efficiency is generally higher than numerical results which adopting the spherical drag law and considering the gravity effect. Moreover, a threshold value of the Stokes number that determines the deviation between numerical and semi-analytical approaches is presented. When the Stokes number is greater than the threshold, a relatively small deviation can be achieved. It is concluded that the new pressure drop correlation can provide guidance for macro-scale model to study the filtration performance. As well, the correlation calculating of filtration efficiency between numerical simulation and semi-analytical model is obtained by using the Peclet number and the Stokes number as criteria.</p>

Pressure drop model for fibrous media in depth filtration: Coupling simulation of microstructure and CFD porous media during dust loading

Development and Validation of Filtered Drag Models for Fluidization of Low-Density Geldart A Particles

Investigation of the filtration performance for fibrous media: Coupling of a semi-analytical model with CFD on Voronoi-based microstructure

The pressure drop of fibrous surface filters for gas Filtration: Modeling and experimental studies

Finite Volume Method of the Microfiltration of Viscoelastic Polymer Solution

Numerical Studies on Filter of Piping in Broadly Graded Cohesionless Soils

Study of structural factors of structure-resolved filter media on the particle loading performance with microscale simulation

A macroscale model for simulating pressure drop and collection efficiency of pleated filters over time

Coupled Filtration-Consolidation Model for Vacuum-Preloaded Soft Ground

Influence of pleated geometry on the pressure drop of filters during dust loading process: experimental and modelling study

Clogging and Unclogging of Fine Particles in Porous Media: Micromechanical Insights From an Analog Pore System

High fidelity simulation of ultrafine PM filtration by multiscale fibrous media characterized by a combination of X-ray CT and FIB-SEM

Optimization on the performance of fibrous filter through computational fluid dynamic simulation coupled with response surface methodology

Analysis and Simulation of Fluid-Particles Interaction with Particle Flow Code

Numerical Study on Clogging of Prefabricated Vertical Drain in Slurry under Vacuum Loading

Compressional Rheology Model for Vacuum Filtration-Consolidation of Sludge in Geotextile Tubes

Modeling of the Minimum Fluidization Velocity and the Incipient Fluidization Pressure Drop in a Conical Fluidized Bed with Negative Pressure

Understanding the Microscopic Mechanism of Clogging of both Fibrous and Mesh Filters in Flooded-bed Wet Scrubbers

Numerical simulation of particle spatial distribution and filtration characteristic in the pleated filter media using OpenFOAM

Radial Filtration Model of Clogging Column for Prefabricated Vertical Drain Treatment of Slurry

Lumped model for evaluating dynamic filtration and pressure drop behaviour in diesel particulate filters