Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

Conjugate heat transfer and flow around tandem tubes: Effect of thermophysical parameters and tube arrangement

Theoretical and Experimental Analyses of Two-Phase Flow Condensation Heat Transfer Inside the Horizontal Micro-Fin Tube

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Heat Transfer Performance of Microfin Tubes and -Three-dimensional Heat Transfer Tubes

Experimental Study on Heat Transfer Performance and Flow Pattern in Micro-Fin Tubes and 1EHT Three-Dimensional Heat Exchange Tubes

Numerical Investigation of Two-Phase Flow Through Tube Bundles Based on the Lattice Boltzmann Method

Condensation Characteristics of Flows in Newly Developed, Three-Dimensional Enhanced Heat Transfer Tubes

Single Phase And Two Phase Flow Characteristics And Heat Transfer In Micro-Fin Tubes

Tubes with Heat Transfer Property Intensified by Multi-longitudinal Vortices According to the Field Coordination Theory

Thermal Circuit Modeling and Numerical Verification for Concurrent Fluid Flows through an Iso-Flux Heated Concentric Double Tube

Boiling and Condensation Two-Phase Flow Heat Transfer on Three-Dimensional Macroscale Surfaces with Microscale Structures

Numerical Study of a Power Plant Condenser Tube Arrangement

Numerical Simulation and Optimization of Enhanced Heat Transfer in Helical Oval Tubes: Effect of Helical Oval Tube Modification, Pitch Ratio, and Depth Ratio

Thermal-Hydraulic Performance and Optimization of Tube Ellipticity in a Plate Fin-And-Tube Heat Exchanger

An experimental study of annular film flow condensation in a micro-fin tube with high mass flux

Supercritical CO 2 flow and heat transfer through tapered horizontal mini-tubes: Parametric analysis and optimization study

An Experimental Investigation to Determine the Effect of Tube Material on the Tubeside Heat Transfer Performance of the Enhanced 1EHT Three Dimensional Heat Transfer Tube

R410A Flow Condensation Inside Two Dimensional Micro-Fin Tubes and Three Dimensional Dimple Tubes

Condensation and Evaporation Heat Transfer Characteristics of Low Mass Fluxes in Horizontal Smooth Tube and Three-Dimensional Enhanced Tubes

An Experimental Study of In-Tube Condensation and Evaporation Using Enhanced Heat Transfer (EHT) Tubes

Two-phase Heat Transfer Correlations in Three-Dimensional Hierarchical Tube