Abstract:A discrete element method (DEM) model is developed to simulate the dynamics of wet, flexible fibers. The angles of repose of dry and wet fibers are simulated, and the simulation results are in good agreement with experimental results, validating the wet, flexible fiber model. To study wet fiber flow behavior, the model is used to simulate shear flows of wet fibers in a periodic domain under Lees-Edwards boundary conditions. Significant agglomeration is observed in dilute shear flows of wet fibers. The size of the largest agglomerate in the flow is found to depend on a Bond number, which is proportional to liquid surface tension and inversely proportional to the square of the shear strain rate. This Bond number reflects the relative importance of the liquid-bridge force to the particle's inertial force, with a larger Bond number leading to a larger agglomerate. As the fiber aspect ratio (AR) increases, the size of the largest agglomerate increases, while the coordination number in the largest agglomerate initially decreases and then increases when the AR is greater than four. A larger agglomerate with a larger coordination number is more likely to form for more flexible fibers with a smaller bond elastic modulus due to better connectivity between the more flexible fibers. Liquid viscous force resists pulling of liquid bridges and separation of contacting fibers, and therefore it facilitates larger agglomerate formation. The effect of liquid viscous force is more significant at larger shear strain rates. The solid-phase shear stress is increased due to the presence of liquid bridges in moderately dense flows. As the solid volume fraction increases, the effect of fiber-fiber friction coefficient increases sharply. When the solid volume fraction approaches the maximum packing density, the fiber-fiber friction coefficient can be a more dominant factor than the liquid bridge force in determining the solid-phase shear stress.

Experimental Study of the Dynamics of Coating Flow on Fiber Array

Threading Behavior and Dynamics of Ring-Linear Polymer Blends under Poiseuille Flow

Experimental Research on the Hydrodynamic Instability of Fiber Suspensions in Channel Flow

Fiber Orientation Distributions in a Suspension Flow Through a Parallel Plate Channel Containing a Cylinder

Fiber Orientation Distributions in Slit Channel Flows with Abrupt Expansion for Fiber Suspensions

Experimental Investigation on Flow Past Nine Cylinders in a Square Configuration

Effect Of Fiber Additives On Flow In Journal Bearings

Rheological behavior of fiber suspensions in a turbulent channel flow.

Flow State Transition and Hydrodynamic Characteristics of Droplets on Fiber in Liquid Phase Environment

Static wetting of a barrel-shaped droplet on a soft-layer-coated fiber

Orientational Distribution of Fibres in Sheared Fibre Suspensions

Discrete element simulation studies of angles of repose and shear flow of wet, flexible fibers.

Long-distance Liquid Transport Along Fibers Arising From Plateau-Rayleigh Instability

The Dynamics Characteristics of Droplet Coalescence on Fiber

Numerical Research on the Orientation Distribution of Fibers Immersed in Laminar and Turbulent Pipe Flows

Film coating by directional droplet spreading on fibers

Dynamics of flexible fibers in confined shear flows at finite Reynolds numbers

Multiple droplets on a conical fiber: formation, motion, and droplet mergers

Coarse-graining the dynamics of immersed and driven fiber assemblies

Shear Flow Behaviors of Rod-Coil Diblock Copolymers in Solution: A Nonequilibrium Dissipative Particle Dynamics Simulation

Wetting morphologies on an array of fibers of different radii