Abstract:The results of experimental studies on the optimal method of testing materials for hardness depending on physical and mechanical properties are presented. The possibility of evaluating the structural parameters, i.e., the homogeneity coefficients and the variation of the reliability of various devices for obtaining the hardness values of rolled metal products, is considered. The results obtained experimentally have shown the effectiveness of such evaluations. The reliability of the methods for testing the hardness of materials of different plasticities was controlled by determining the degree of dispersion of the obtained results by the LM-hardness method. The influence of the material's physical and mechanical characteristics on the hardness test's accuracy is analyzed. The possibility of choosing the most reliable Brinell, Vickers, or Rockwell method for determining hardness characteristics depending on the level of plastic properties of the sheet material was determined. Following Fisher's theory of small samples in terms of the general population, a statistical assessment of the reliability of measurement methods was performed on a sample of a limited size, which makes it possible to assess the reliability of the results of hardness determination by various methods and determine the optimal variant of testing materials, including high-strength ones, for hardness. According to the methodology for analyzing variance to select the optimal variant for conducting studies of material hardness, the statistical assessment of the reliability of hardness measurements was carried out using a random sample from the general population in its central part in the number of five measurements following each other. The variance check is applied using the Cochrane criterion to determine the uncertain members of the variation series. Based on the research results, the predominant expediency of one or another Brinell, Vickers, or Rockwell method of conducting hardness tests depending on the level of plasticity of materials, especially high-strength ones, given their structural state as assessed by the parameters of hardness characteristics scattering – homogeneity coefficients m and variation v . The availability of this information will make it possible to determine the mechanical characteristics of materials by hardness values more reliably.

Experimental Determination of the Optimal Hardness Testing Method Depending on the Material's Physical and Mechanical Properties

Fatigue hardening/softening behaviour investigated through Vickers microhardness measurement during high-cycle fatigue

Mechanics analysis and simulation of material Brinell hardness measurement

On the Application of Vickers Micro Hardness Testing to Isotactic Polypropylene

A Method for Estimating the Mechanical Parameters of the Laminae of Laminated Rocks Based On Uniaxial Compression and Tensile Tests

Determination of elastic moduli of polymeric materials using microhardness indentation

Studying the values of distribution of chromium-nickel steel microhardness using statistical methods

Microhardness, Indentation Size Effect and Real Hardness of Plastically Deformed Austenitic Hadfield Steel

Determination of material parameters of rubber and composites for computational modeling based on experiment data

Determination of the Mechanical Properties of Metallic Thin Films and Substrates from Indentation Tests

On the Determination of Reduced Young's Modulus and Hardness of Elastoplastic Materials Using a Single Sharp Indenter

Evaluation of Hardness and Elastic Modulus of Polymer Materials Through Micro-Scratch Method: An Empirical Study

Data-driven estimation of plastic properties in work-hardening model combining power-law and linear hardening using instrumented indentation test

Recent metrological approaches relevant to the characterisation of hardmetals

Inverse Method to Determine Parameters for Time-Dependent and Cyclic Plastic Material Behavior from Instrumented Indentation Tests

Investigation of the hydrostatic and plastic zones in hardness measurement using finite element simulation

Minimum Thickness Requirements for Rockwell Hardness Testing

A statistical approach to the mechanical testing of dental materials

Determination Of The Effective Dynamic Yield Strength Of Heterogeneous Materials

DETERMINATION OF THE DYNAMIC YOUNG'S MODULUS AND POISSON'S RATIO OF BRITTLE MATERIALS

Recent Study on the Related Problems in Evaluation of Mechanical Properties for Mems Materials