Non-Woven Fibrous Polylactic Acid/Hydroxyapatite Nanocomposites Obtained via Solution Blow Spinning: Morphology, Thermal and Mechanical Behavior

Javier González-Benito,Stephania Zuñiga-Prado,Julian Najera,Dania Olmos

DOI: https://doi.org/10.3390/nano14020196

IF: 5.3

2024-01-15

Nanomaterials

Abstract:Polylactic acid (PLA) is widely used in tissue engineering and other biomedical applications. PLA can be modified with appropriate biocompatible ceramic materials since this would allow tailoring the mechanical properties of the tissues to be engineered. In this study, PLA-based non-woven fibrillar nanocomposites containing nanoparticles of hydroxyapatite (HA), a bioceramic commonly used in bone tissue engineering, were prepared via solution blow spinning (SBS). The compositions of the final materials were selected to study the influence of HA concentration on the structure, morphology, and thermal and mechanical properties. The resulting materials were highly porous and mainly constituted fibers. FTIR analysis did not reveal any specific interactions. The diameters of the fibers varied very little with the composition. For example, slightly thinner fibers were obtained for pure PLA and PLA + 10% HA, with fiber diameters of less than 400 nm, while the thicker fibers were found for PLA + 1% HA, with average diameters of 427 ± 170 nm. The crystallinity and stiffness of the PLA/HA composite increased with the HA content. Further, composites containing PLA fibers with slightly larger diameters were more ductile. Thus, with an appropriate balance between factors, such as the diameter of the solution-blow-spun PLA fibers, HA particle content, and degree of crystallinity, PLA/HA composites may be effectively used in tissue engineering applications.

materials science, multidisciplinary,physics, applied,nanoscience & nanotechnology,chemistry

What problem does this paper attempt to address?

The main problem that this paper attempts to solve is to prepare polylactic acid (PLA) and hydroxyapatite (HA) nanoparticle composites through Solution Blow Spinning (SBS) technology, and to study the structure, morphology, thermal and mechanical properties of these composites. Specifically, the author hopes to optimize the mechanical properties and crystallinity of the composites by adjusting the content of HA nanoparticles, making them more suitable for tissue engineering applications. The paper also explores the influence of different HA contents on the fiber diameter and how these changes affect the overall performance of the materials. Through this research, the author hopes to provide new possibilities for the development of PLA/HA composites suitable for specific tissue engineering applications.