Determining the Hot Workability and Microstructural Evolution of an Fe-Cr-Mo-Mn Steel Using 3D Processing Maps

Cunchao Dou,Zhendong Sun,Depeng Shen,Ning Guo,Zhe Liu,Lin Cheng,Yongchao Liu,Bingtao Tang

DOI: https://doi.org/10.3390/ma17112715

IF: 3.4

2024-06-04

Materials

Abstract:The Laasraoui segmented and Arrhenius flow stress model, dynamic recrystallization (DRX) model, grain size prediction model, and hot processing map (HPM) of Fe-Cr-Mo-Mn steels were established through isothermal compression tests. The models and HPM were proven by experiment to be highly accurate. As the deformation temperature decreased or the strain rate increased, the flow stress increased and the grain size of the Fe-Cr-Mo-Mn steel decreased, while the volume fraction of DRX (Xdrx) decreased. The optimal range of the hot processing was determined to be 1050–1200 °C/0.369–1 s−1. Zigzag-like grain boundaries (GBs) and intergranular cracks were found in the unstable region, in which the disordered martensitic structure was observed. The orderly packet martensite was formed in the general processing region, and the mixed structure with incomplete DRX grains was composed of coarse and fine grains. The microstructure in the optimum processing region was composed of DRX grains and the multistage martensite. The validity of the Laasraoui segmented flow stress model, DRX model, grain size prediction model, and HPM was verified by upsetting tests.

materials science, multidisciplinary,metallurgy & metallurgical engineering,physics, applied,chemistry, physical, condensed matter

What problem does this paper attempt to address?

### Problems the Paper Attempts to Solve

This paper primarily explores the hot working performance and microstructural evolution of Fe-Cr-Mo-Mn steel during the hot deformation process. Specifically, the paper attempts to address the following issues:

1. **Establishing a Hot Deformation Behavior Model**:
- Through isothermal compression experiments, the Laasraoui segmented flow stress model, dynamic recrystallization (DRX) model, and grain size prediction model were established.
- The accuracy of these models was verified, and the changes in flow stress and microstructure under different temperature and strain rate conditions were studied.

2. **Determining Optimal Hot Working Parameters**:
- The optimal hot working range was determined to be 1050–1200 °C / 0.369–1 s⁻¹.
- The microstructural characteristics in different hot working regions (unstable zone, general processing zone, and optimal processing zone) were analyzed, including serrated grain boundaries, intergranular cracks, disordered martensitic structure, ordered packet martensite, and mixed structures.

3. **Validating the Effectiveness of the Models**:
- The effectiveness of the established Laasraoui segmented flow stress model, DRX model, and grain size prediction model was validated through upsetting experiments.

In summary, the paper aims to optimize the hot working process of Fe-Cr-Mo-Mn steel by establishing and validating hot deformation behavior models, thereby improving its forming quality and performance.