Abstract:The effects of sludge content and pyrolysis temperature on the pyrolysis process and product properties were studied through the co-pyrolysis of sludge and cotton stalk. Multi-objective fuzzy hierarchical analysis was used to analyze the multiphase properties of pyrolysis products, and describe the internal relationship between pyrolysis conditions and product properties. It has been proved using kinetic calculation that the mass ratio of sludge and cotton stalk is higher than 1:2 required the lower pyrolysis activation energy. According to the comparison between experimental and theoretical results, the addition of sludge is beneficial to increase the bio-oil yield. In terms of product performance, the addition of sludge and increase of pyrolysis temperature both can improve the specific surface area, pore volume of biochar and the pH value of bio-oil, reduce the total acid content, increase the total phenol content and optimize calorific value of bio-oil. The specific surface area of biochar, calorific value of bio-oil, total phenol content and pH were evaluated by multi-objective decision analysis method, the optimum process condition of sludge: cotton stalk = 2:1 at 600 °C. Under the conditions, the specific surface area of biochar is 57.40 m 2 /g, the pH of the bio-oil is 8.06, the total acid content is 5.94 mg/g, the calorific value is 27.18 KJ/g and the total phenol content is 47.32 mg/g, respectively. Compared to the pyrolysis product of cotton stalks, the specific surface area is increased almost 20 times, the calorific value is increased by 13%, the total acid content is decreased by 95%, and the total phenol content is similar. This study proposed a preparation process of bio-oil with high performance, and provided a theoretical basis for the subsequent co-pyrolysis research.

An approach for upgrading biomass and pyrolysis product quality using a combination of aqueous phase bio-oil washing and torrefaction pretreatment

Combined pretreatment with torrefaction and washing using torrefaction liquid products to yield upgraded biomass and pyrolysis products

In-depth Study of Synergism Between Torrefaction and Catalyst for Balanced Production of Bio-Oil from Rice Husk Pyrolysis Based on Hydrocarbons Production, Energy Yield and Deoxygenation Degree

Investigation of improving the yields and qualities of pyrolysis products with combination rod-milled and torrefaction pretreatment

Effect of aqueous phase bio-oil and its typical organic matter washing pretreatment on catalytic pyrolysis characteristics of biomass

Advancing biomass pyrolysis by torrefaction pretreatment: Linking the productions of bio-oil and oxygenated chemicals to torrefaction severity

Torrefaction of biomass stalk and its effect on the yield and quality of pyrolysis products

Optimizing invasive plant biomass valorization: Deep eutectic solvents pre-treatment coupled with ZSM-5 catalyzed fast pyrolysis for superior bio-oil quality

Microwave-assisted catalytic upgrading of co-pyrolysis vapor using HZSM-5 and MCM-41 for bio-oil production: Co-feeding of soapstock and straw in a downdraft reactor

Bio-oil upgrading by reactive distillation using p-toluene sulfonic acid catalyst loaded on biomass activated carbon

Improvement of wheat (T. aestivum) straw catalytic fast pyrolysis for valuable chemicals production by coupling pretreatment of acid washing and torrefaction

Effects of different pretreatment methods on millet straw and millet bran for fuel properties and pyrolysis bio-oil

A novel three-stage ex-situ catalytic pyrolysis process for improved bio-oil yield and quality from lignocellulosic biomass

Study on the properties and components of solid-liquid products by co-pyrolysis of sludge and cotton stalk

Synergetic deoxygenation and demineralization of biomass by wet torrefaction pretreatment and its influence on the compound distribution of bio-oil during catalytic pyrolysis

Effect of torrefaction and fractional condensation on the quality of bio-oil from biomass pyrolysis for fuel applications

Washing walnut shells with the aqueous part of pyrolysis liquids: effect on biomass and pyrolysis product quality

Recent advances in improving lignocellulosic biomass-based bio-oil production

Preparation of bio-oil enriched with phenolic compounds by combining acid-washing pretreatment and condensation technology

Effect of the combined pretreatment of leaching and torrefaction on the production of bio-aromatics from rice straw via the shape selective catalytic fast pyrolysis

One Step Bio-Oil Upgrading through Hydrotreatment, Esterification, and Cracking