Effect of dilute acid on fulvic acid extracted from lignite

Di WuJirui LuLitong Maa School of Chemistry and Chemical Engineering,Inner Mongolia University of Science and Technology,Baotou,Chinab Inner Mongolia Engineering Research Center for Comprehensive Utilization of Bio-coal Chemical Industry,Baotou,Inner Mongolia,Chinac Inner Mongolia Key Laboratory of Mining Engineering. Inner Mongolia University of Science and Technology,Baotou
DOI: https://doi.org/10.1080/19392699.2024.2339326
2024-04-24
International Journal of Coal Preparation and Utilization
Abstract:To explore the effect of dilute acid on the extraction of fulvic acid by lignite using an alkali-soluble acid precipitation method, lignite was acid-precipitated by H 2 SO 4 , HNO 3 , HCl, and H 3 PO 4 , and the content, extraction rate, and structural characteristics of fulvic acid were analyzed. The results showed that the highest content of humic acid extracted by HNO 3 is 0.3383 mg/mL, and the lowest content of humic acid extracted by sulfuric acid is 0.0817 mg/mL. The highest extraction rate of humic acid derived from lignite extracted by hydrochloric acid is 3.84%, and the lowest extraction rate of humic acid extracted by sulfuric acid is 0.89%. Fulvic acid extracted from lignite contained functional groups such as benzyl, carbonyl, methyl, and hydroxyl, but their contents varied; the benzene ring structure in fulvic acid precipitated by HNO 3 was the most pronounced, but the aromatization degree was the lowest. By contrast, the aromatization degree of fulvic acid precipitated by H 2 SO 4 was the highest. This indicates that the functional group contents in humic acid extracted from different dilute acids vary, although the types of functional groups are similar.
energy & fuels,mining & mineral processing
What problem does this paper attempt to address?